Coolant Temperature Sensor - Remove and Install
- Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Show/hide table
Illustration 1 g03782627 - Disconnect harness assembly (2) and remove coolant temperature sensor (1).
- Install coolant temperature sensor (1) in the reverse order of removal.
- Tighten coolant temperature sensor (1) to a torque of
20 ± 3 N·m (177 ± 27 lb in) .
Note: Do not pre-tighten the sensor using the plastic portion of the sensor. Pre-tighten the sensor using the metal hex portion of the sensor. Damage can occur to the sensor if pre-tightened using the plastic portion of the sensor.
- Tighten coolant temperature sensor (1) to a torque of
Caterpillar Information System:
2015/01/06 Event Codes (E2131, E2132, or E2133) Appearing Occasionally with On-board Machine Systems with a PL321, or PL121 Satellite System Installed {7600, 7606}
C7 Marine Engine Maintenance Interval Schedule - Commercial Ratings
C280 Marine Engines Exhaust System Contains Oil
C7 Marine Engine Maintenance Interval Schedule - High Performance
C13 Generator Set Engine Crankshaft Position Sensor - Remove and Install
C13 Generator Set Engine Camshaft Position Sensor - Remove and Install
2014/12/19 New Differential Pressure Lines Routing Is Used For All C9.3 to C18 Tier 4 Interim Industrial Engines {108D}
C13 Generator Set Engine Atmospheric Pressure Sensor - Remove and Install
XQ375 and XQ425 Rental Generator Sets Product Lifting
C3.4B Engines Indicator Lamp - Test
XQ375 and XQ425 Rental Generator Sets Plate Locations and Film Locations
C7.1 Engines Engine Shutdown Occurrence
C9 Marine Engines Overhaul (Major)
C4.4 and C6.6 Engines Engine Overcrank Occurrence
C7.1 Engines Engine Shutdown Occurs Intermittently
C7.1 Engines Engine Stalls at Low RPM
C7.1 Engines Engine Top Speed Is Not Obtained
Inspection of the Fan Drive Pulley and Belts{1357, 1358, 1359} Inspection of the Fan Drive Pulley and Belts{1357, 1358, 1359}
Installing the New Delta Pressure Lines on Certain Tier 4 Interim C9 To C18 Engines {108D} Installing the New Delta Pressure Lines on Certain Tier 4 Interim C9 To C18 Engines {108D}
C13, C15, and C18 Tier 4 Final Engines Event Codes
C280 Marine Engines Electronic Service Tool Does Not Communicate
C15 and C18 Engines Engine Operation
2014/12/19 New Engine Software Is Available For Certain G3306B Engines {1920}
C1.5 and C2.2 Industrial Engines Diesel Particulate Filter Temperature Is Low