3512E Land Electric Drive Caterpillar


Fuel System Primary Filter - Replace

Usage:

3512E BZ3

------ WARNING! ------

Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.


Table 1
ISO Cleanliness Standards and Fuel Filter Service Life 
ISO Cleanliness  Filter Service Interval (Hours) 
ISO 18  1000 
ISO 19  900 
ISO 20  775 
ISO 21  650 
ISO 22  500 
ISO 23  up to 350 


NOTICE

Cat fuel filters are built to Cat specifications. Use of fuel filters not recommended by Caterpillar could result in damage to the fuel system, and other components. This damage is the result of contaminants and other particles from unfiltered fuel entering the fuel system. Only use fuel filters recommended by Caterpillar.


  1. Stop the engine. Ensure that the engine will not start during this procedure.

  2. Shut off the fuel supply valve to the engine.


    NOTICE

    Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.



    NOTICE

    Use a suitable container to catch any fuel that might spill. Clean up any spilled fuel immediately.




    Illustration 1g03754121

  3. Loosen drain valve (1). Prepare to catch the fuel that is inside the filter case with a suitable container.

  4. Unscrew the element (2) with a suitable Cat filter strap wrench.

  5. Inspect the O-ring seals. Obtain new seal rings if the old seal rings are damaged or deteriorated. Ensure that the sealing surfaces for the seals are clean. Install the seals.


    NOTICE

    Do not fill the fuel filters with fuel before installing them. The fuel would not be filtered and could be contaminated. Contaminated fuel will cause accelerated wear to fuel system parts.


  6. Place the element on to the base.

  7. Thread the element onto the base until the seal contacts the base.

  8. Tighten the element according to the instructions listed on the element.

  9. Prime the fuel system. See this Operation and Maintenance Manual, "Fuel System - Prime" topic.

Caterpillar Information System:

Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.