Relay (ARD Nozzle Heater) - Remove and Install
- Remove cable strap (4). Disconnect harness assembly (3).
- Remove bolts (1) and remove relay (2).
Show/hide table
| |
| Illustration 1 | g03754198 |
- Install relay (2) in the reverse order of removal.
- Tighten bolts (1) to a torque of
12 ± 3 N·m (106 ± 27 lb in) .
- Tighten bolts (1) to a torque of
Caterpillar Information System:
C4.4 Engines Coolant Level Is Low
C4.4 and C7.1 Engines Coolant Contains Oil
2014/12/05 New Exhaust Shield Assemblies Are Now Available on Certain G3520C Engines {1059}
793F and 797F Off-Highway Trucks Power Train Electronic Control System MID 081 - CID 0673 - FMI 07
2014/11/21 New Monitor Software Gp Is Now Used on Certain C18, and C32 Marine Engines {7490, 7620}
C13 Generator Set Engine Combustion Head - Remove and Install
C13 Generator Set Engine Solenoid Valve (DEF Heater Coolant) - Remove and Install
793F and 797F Off-Highway Trucks Power Train Electronic Control System MID 081 - CID 0585 - FMI 07
C13 Generator Set Engine Voltage Control (Load Protection) - Remove and Install
C18 Fire Pump Engine Maintenance Interval Schedule
C7.1 Engines Battery Problem
C4.4 and C7.1 Engines Alternator Problem - Charging Problem and/or Noisy Operation
C8.7 Marine Engines Crankshaft
3512E Land Electric Drive Fuel System Primary Filter - Replace
C280-16 Engine Alternator - Inspect
390F Excavator Machine System Pump Control (Output Flow) - Test - One Pump Calibration
C13 Generator Set Engine Exhaust Manifold - Remove and Install
C280 Marine Engines Coolant Contains Oil
C280 Marine Engines Cat ET Service Error Identifiers
3512E HD Petroleum Engine Safety Messages
C13 Generator Set Engine Catalyst (SCR) - Remove and Install
3512E HD Petroleum Engine Model View Illustrations
C4.4 and C6.6 Engines Coolant Temperature Is High
3512E Land Electric Drive Engine Electronics