An Improved Engine Oil Filter Element Is Used for Certain C175 Commercial Engines {1308}
- Electric Power Generation:
- C175-16 (S/N: WYB1-UP)
- Engine:
- C175-16 (S/N: WYC1-UP; R1X1-UP; 3A91-UP)
- C175-20 (S/N: BXR1-UP)
Description of Change: An improved adhesive is used between the engine oil filter top plate and the oil filter seal.
Adaptable To: The improved 368-0066 Engine Oil Filter Element replaces the existing oil filter element. The improved engine oil filter element is adaptable back to first production on the serial numbers listed above.
Show/hide table
Illustration 1 | g03587970 |
(1) "K" mark on oil filter element |
The new engine oil filter element can be identified by a "K" mark on the filter. Refer to Illustration 1.
This change is effective for the serial numbers listed in Table 1.
Show/hide table
Effective Serial Numbers     |
S/N:3A900120-UP     |
S/N:R1X00105-UP     |
S/N:WYB01461-UP     |
S/N:WYC01002-UP     |
S/N:BXR01029-UP     |
Caterpillar Information System:
390F Excavator C18 Engine Supplement Manifold (DEF Heater) - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Gear Group (Rear) - Remove
390F Excavator Refrigerant Compressor - Remove and Install
349F and 352F Excavators Machine System Specifications Suction Fan
349F and 352F Excavators Machine System Specifications Fuel Tank
UPS 750 Uninterruptible Power Supply System Configuration
390F Excavator Engine Front Mount - Remove and Install
2014/05/16 New Software Is Used on Certain Tier 4 Interim Industrial Engines {1901, 1902, 1920}
374F Excavator Alternate Exit
390F Excavator Water Pump - Remove and Install
374F and 390F Excavators and 390F MHPU Mobile Hydraulic Power Unit Manual Hydraulic Valve - Health Check
3500 Generator Sets with Dynamic Gas Blending Gas Filter Condensation - Drain
390F Excavator Enclosure (Cooling System Package) - Remove and Install
390F Excavator Aftercooler - Remove and Install
374F Excavator Leaving the Machine
349F and 352F Excavators Machine System Specifications Pilot Lines
390F Excavator Hydraulic Oil Cooler - Remove and Install - Rear
390F Excavator Hydraulic Oil Cooler - Remove and Install - Front
374F Excavator Machine Systems BLCV and SLCV - Calibrate - If Equipped
374F Excavator Camera Harness - Disconnect and Connect
390F Excavator Radiator - Remove and Install - Front
Required Parts for Installing Turbochargers on Certain 2007 On-Highway Truck Engines {1052, 1053} Required Parts for Installing Turbochargers on Certain 2007 On-Highway Truck Engines {1052, 1053}
C8.7 Marine Engines Air Inlet and Exhaust System
C3.4B Engines Switch Circuits - Test - Engine Oil Pressure Switch