Engine Speed Sensor - Remove and Install
- Disconnect the harness assembly.
- Loosen nut (2).
- Remove speed sensor (1).
- Remove the O-ring seals from speed sensor (1).
Show/hide table
Illustration 1 | g03424918 |
- Install speed sensor (1) in the reverse order of removal.
- Install speed sensor (1) until contact is made on the flywheel gear tooth. Then back out 180° ± 15°.
- Tighten nut (2) to a torque of
25 ± 5 N·m (18 ± 4 lb ft) .
Caterpillar Information System:
C13 Generator Set Engine Fuel Temperature Sensor - Remove and Install
XQC1600 Power Module Safety Messages
C13 Generator Set Engine Fuel Pressure Sensor - Remove and Install
C13 Generator Set Engine Engine Oil Pressure Sensor - Remove and Install
C13 Generator Set Engine Coolant Temperature Sensor - Remove and Install
C13 Generator Set Engine Camshaft Position Sensor - Remove and Install
C13 Generator Set Engine Atmospheric Pressure Sensor - Remove and Install
AP655F Asphalt Paver Diesel Exhaust Fluid Filter - Clean/Replace
C13 Generator Set Engine Cylinder Head - Remove and Install
C13 Generator Set Engine Valve Mechanism Cover Base - Remove and Install
3516C Petroleum Engines Air Lines
C7.1 Industrial Engine Battery - Replace
C13 Generator Set Engine Turbocharger Outlet Pressure Sensor - Remove and Install
C13 Generator Set Engine Inlet Air Temperature Sensor - Remove and Install
CX31-P600 Petroleum Transmission Safety Messages
794 AC Off-Highway Truck Fuel System - Fill - Fast Fill Fuel Adapter
794 AC Off-Highway Truck Breather (Fuel Tank) - Replace
2013/10/01 Flow Control Valve (FCV) Solenoid on Certain C3.4 Engines {1251, 1290}
2013/08/26 New Fuel Injector Return Lines Are Used On Certain C175 Engines {1252, 1254}
C175-16 Locomotive Engine Exhaust Support
G3306B Petroleum Generator Set Engines CAN Data Link - Test
G3306B Petroleum Generator Set Engines Electrical Power Supply - Test
G3306B Petroleum Generator Set Engines Fuel Actuator - Test
G3306B Petroleum Generator Set Engines Fuel Shutoff - Test