1994/01/01 Caterpillar


Possible Interference Problem With 9U-7241 Valve Spring Compressor Group{0703}

Usage:


3406E Truck Engines

The 9U-7241 Valve Spring Compressor Group may bind when being used to compress the valve springs on 3406E Truck Engines. The 9U-7548 Compressor Base Assembly (part of the 9U-7241 Valve Spring Compressor Group) may not be machined to the correct diameter. This may cause the compressor base assembly to tilt when the injector clamp bolt is tightened.

Measure the small diameter (A) of the 9U-7548 Compressor Base Assembly. See the illustration. Diameter (A) should be 23.00 ± 0.25 mm (.905 ± .010 in). If diameter (A) is not correct, it can be machined to the correct diameter or the 9U-7241 Valve Spring Compressor Group may be returned for warranty.


Location to measure diameter (A) on the 9U-7548 Compressor Base Assembly.

Caterpillar Information System:

1994/01/01 Exhaust Valve Bridge Should Not Be Adjusted{1119}
1994/01/01 Cold Weather Operation{0374}
1994/01/01 New Valve Cover Gasket Used{1107}
1993/12/01 Uses, Characteristics, And Removal of Castrol Tarp®, Tarp-B®, And 4164®{0374}
1993/12/01 Procedure To Prevent Moisture From Collecting In The Hose Between The Air Inlet Manifold And Transducer Module (Boost Sensor){1917}
1993/12/01 Clarify Usage Of Parts Service Cylinder Head Gaskets{1124}
1993/12/01 Replacement Of Earlier Truck Engines In General Motors Topkick And Kodiak Trucks{1000}
1993/12/01 New Control Assemblies Used In Fuel Injection Control Groups{1298}
1993/11/01 8T-8697 Electronic Control Analyzer Programmer (ECAP) Improved
1993/11/01 New Dynamic Fuel Ratio Control (FRC) Settings Provide Improved Engine Response
1993/11/01 Low Power Complaints Caused By 9X7793 Rack Sensor Non-Linearity On Electronic Engines
1993/11/01 On Highway Dynamic Engine Response Test
1994/01/01 Cylinder Head Gaskets Improved To Provide Better Fire Ring Retention{1124}
1994/01/01 Flywheel Housing to Cylinder Block Joint Improvements{1157,1201}
1994/01/01 New Piston Body Has Improved Bonding Between Iron Band And Aluminum Body{1214}
1994/01/01 Fuel Injection Pump Improvements{1251}
1994/01/01 New Pedal Mounted Throttle Position Sensor Available{1913}
1994/01/01 List of Service Publications{0374}
1994/02/01 New Turbocharger Models Have Left-Hand Threads On Compressor Nut And Turbine Shaft{1053,1052}
1994/02/01 Remove Internal Components From 4P-8454 Cover Assembly{1309}
1994/02/01 September 1993 Personality Module Release Improvements{1902}
1994/02/01 New 7X-1715 Cable Assembly (Small, 40 Pin Breakout) Available{0779,1900}
1994/03/01 New Seal Used In Air Lines Group{1058}
1994/03/01 Improved 1R-0712 Fuel Filter Available{1261}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.