794 AC Off-Highway Truck Caterpillar

Bearing (Power Generator) - Lubricate

Usage:

794 AC HRT

Prepare the machine for maintenance. Refer to Operation and Maintenance Manual, "Prepare the Machine for Maintenance".

Show/hide table




Illustration 1	g03421467

Remove rear lubrication fitting cover (1) and front lubrication fitting cover (2) from the bottom of the power generator. Wipe any debris off the fittings.

Attach a grease meter to a battery powered grease gun. Reset the grease meter.

Note: Use Cat High Speed Ball Bearing Grease on the bearings for the power generator. Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for more information on the recommended grease.

Note: Purge the grease gun if the grease gun was previously used with any other type of grease.

Lubricate the fittings for the bearings in the power generator. Two fittings are located on the front and two fittings are located on the rear. Meter 70 g (2.5 oz) of grease to each of the four locations. Do not overgrease the bearings in the power generator

Note: For information on special tooling including the grease meter and battery powered lubrication gun, consult your Cat dealer.

Install the covers.

Caterpillar Information System:

C15 and C18 Engines for China On-Highway Phase IV Crankcase Pressure Is High

C15 and C18 Engines for China On-Highway Phase IV Coolant Temperature Is High

C15 and C18 Engines for China On-Highway Phase IV Coolant Level Is Low

C15 and C18 Engines for China On-Highway Phase IV ARD Is Disabled

C4.4 Industrial Engine Configuration Parameters

349F and 352F Excavators Parking

C4.4 Industrial Engine Diagnostic Flash Code Retrieval

C15 and C18 Engines for China On-Highway Phase IV Event Codes

349F and 352F Excavator Machine System Wiring Harness (Short Circuit) - Test

349F and 352F Excavator Machine System Wiring Harness (Open Circuit) - Test

C175-16 Locomotive Engine Flywheel

C175-16 Locomotive Engine Exhaust Diffuser Adapter

C15 and C18 Engines for China On-Highway Phase IV Crankcase Pressure Is Low

C15 and C18 Engines for China On-Highway Phase IV Diesel Particulate Filter Collects Excessive Soot

C15 and C18 Engines for China On-Highway Phase IV Diesel Particulate Filter Has Changed Regeneration Interval

C15 and C18 Engines for China On-Highway Phase IV Diesel Particulate Filter Has High Ash Load

C15 and C18 Engines for China On-Highway Phase IV Diesel Particulate Filter Temperature Is High

794 AC Off-Highway Truck Cover (Coupler Adapter) - Clean/Inspect

C15 and C18 Engines for China On-Highway Phase IV Diesel Particulate Filter Temperature Is Low

C15 and C18 Engines for China On-Highway Phase IV Engine Cranks but Does Not Start

C15 and C18 Engines for China On-Highway Phase IV Engine Overspeeds

C15 and C18 Engines for China On-Highway Phase IV Engine Shutdown Occurrence

C15 and C18 Engines for China On-Highway Phase IV Engine Shutdown Occurs Intermittently

C15 and C18 Engines for China On-Highway Phase IV Engine Shutdown While Idling