Wire Relocation Required on Certain G3520 Generator Set Engines {1408, 7451}
- Engine:
- G3520E (S/N: GZE213-215)
The 329-4394 Panel Harness As is incorrectly wired. Moving the wire will eliminate the false 1167-2 EPG Circuit Breaker : Erratic, Intermittent, or Incorrect being generated. The procedure that follows will resolve the issue stated above.
Show/hide table
 |
Bodily contact with electrical potential can cause bodily injury or death. To avoid the possibility of injury or death, ensure that the main power supply has been disconnected before performing any maintenance or removing any modules. |
 |
- Remove input wire A320-A009-Pink-18 AWG from J1-56.
- Install wire A320-A009-Pink-18 AWG in the J1-11 terminal on the primary ECM.
Note: Refer to Schematic, KENR5934, "G3520E+ Generator Set Engine Electrical System (Interactive) 329-4396-04" for terminal and wire locations.
Caterpillar Information System:
2013/08/13 New Software Is Now Used on Certain C175 Commercial Engines {1920}
2013/10/31 New Auxiliary Water Pump Groups Are Used on Certain 3500 and G3500 Commercial Engines {1361}
2014/02/17 An Improved Foot Valve Assembly for the Fuel Transfer Pump Is Now Available as a Service Replacement on Certain 300D and 300E Series Excavators and Mobile Hydraulic Power Units {1256}
Engine Oil Contains Elevated Lead (Pb) {1348} Engine Oil Contains Elevated Lead (Pb) {1348}
C15 and C18 Industrial Engines Engine Oil Pan - Remove and Install
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Quick Coupler Operation - Manual Pin Grabber Quick Coupler (If Equipped)
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Operating Technique Information
300.9D and 300.9D VPS Mini Hydraulic Excavator Crushing Prevention and Cutting Prevention
C15 and C18 Industrial Engines Cylinder Head - Remove and Install
3500B and 3500 Marine Propulsion Engines with EUI Option Hoses and Clamps - Replace
C7 Petroleum Engine Fluid Recommendations
C7 Petroleum Engine Refill Capacities
2013/12/05 New Valve Spring Assemblies Are Used for Certain G3500C and G3500E Engines and Power Modules {1100}
C7 Petroleum Engine Product Description
C15 and C18 Industrial Engines Crankshaft Position Sensor - Remove and Install
C15 and C18 Industrial Engines Temperature Sensor (Catalyst Inlet) - Remove and Install
C15 and C18 Industrial Engines Belt Tensioner - Remove and Install
C13 Generator Set Declaration of Conformity
2013/07/01 Additional Cable Straps Are Used on Certain C175 Engines {1408, 7553}
C15 and C18 Industrial Engines Clean Emissions Module - Remove and Install
3516C Petroleum Well Service Engine Engine Stopping
3516C Petroleum Well Service Engine Engine Electronics
C15 and C18 Industrial Engines Electronic Control (Aftertreatment) - Remove and Install
C15 and C18 Industrial Engines Valve Mechanism Cover - Remove and Install