Exhaust Elbow - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 439-3938 | Link Bracket | 2 |
Start By:
- Remove the turbochargers.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (2), adapter (1), and gasket.
Show/hide table
Illustration 2 g03393696 - Attach Tooling (A) and a suitable lifting device to exhaust elbow (3). The weight of exhaust elbow (3) is approximately
45 kg (100 lb) . - Remove bolts (4) and exhaust elbow (3).
Show/hide table
Illustration 1 | g03393683 |
- Install exhaust elbow (3) in the reverse order of removal.
Caterpillar Information System:
349F and 352F Excavators Hydraulic System Gear Pump (Pilot) - Test
349F and 352F Excavators Hydraulic System Travel Motor - Test - Measurement of Case Drain Oil
349F and 352F Excavators Hydraulic System Swing Motor - Test - Measurement of Case Drain Oil
C7.1 Marine Generator Set Heat Exchanger - Inspect
C7.1 Marine Generator Set Engine Oil and Filter - Change - Duplex Oil filters
C7.1 Marine Generator Set Fuel System Primary Filter (Water Separator) Element - Replace
3512C Petroleum Engines with Dynamic Gas Blending Fuel Actuator - Test
3512E Tier 4 Final Engines for Land Electric Drilling Sensor Supply - Test
Failure of 12 Volt Electrical Power Converter on Certain Off-Highway Trucks{1408, 1421} Failure of 12 Volt Electrical Power Converter on Certain Off-Highway Trucks{1408, 1421}
3512B and 3516B Generator Set Engines with Dynamic Gas Blending Camshaft Bearing Position
3512B and 3516B Generator Set Engines with Dynamic Gas Blending Fuel Lines
3512B and 3516B Generator Set Engines with Dynamic Gas Blending Fuel Lines
TA2 Technical Inspection for 3512C Dynamic Gas Blending Oil Well Service Engines {0372, 1000, 753T} TA2 Technical Inspection for 3512C Dynamic Gas Blending Oil Well Service Engines {0372, 1000, 753T}
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install - C18 Engine
3516C Petroleum Engines Exhaust Manifold - Remove and Install
2014/05/16 New Water Pump Seal and Pumps Used on Certain 3500, G3500, and C175 Engines {1361, 7555}
New Water Pump Seal and Water Pumps Are Used on Certain 3500 and G3500 Engines {1361} New Water Pump Seal and Water Pumps Are Used on Certain 3500 and G3500 Engines {1361}
C7.1 Marine Generator Set Coolant Sample (Level 1) - Obtain
C175-16 and C175-20 Engines for Off-Highway Trucks Connecting Rod Bearings
C13, C15, and C18 Tier 4 Final Engines Coolant Level Sensor
C7.1 Industrial Engine Product Storage
C32 Generator Set Voltage Regulators - R450T Automatic Voltage Regulator (AVR)
C175-16 Locomotive Engine Engine Oil Temperature Sensor
2013/06/13 New Injection Assemblies Are Equipped with Flow Indicators for Certain Retrofit Selective Catalytic Reduction Systems {108I}