Catalyst (SCR) - Remove and Install
- Remove clamp assembly (1) and temperature sensor (3) from catalyst (SCR) (2).
Show/hide table
Illustration 2 g03345681 - Attach a suitable lifting device to catalyst (SCR) (2). The weight of catalyst (SCR) (2) is approximately
56 kg (124 lb) . - Disconnect clamp assemblies (4).
- Use the suitable lifting device to remove catalyst (SCR) (2).
Show/hide table
Illustration 1 | g03345566 |
Note: When installing a new catalyst or a cleaned catalyst, a SCR reset must be performed. Refer to Special Instruction, REHS8180, "Aftertreatment Filter Maintenance on Tier 4 Final Products Equipped with a Diesel Particulate Filter (DPF), Diesel Oxidation Catalyst (DOC), and a Selective Catalyst Reduction (SCR) Filter" for the correct procedure.
- Install catalyst (SCR) (2) in the reverse order of removal.
- Tighten clamp assembly (1) to a torque of
35 ± 2 N·m (26 ± 1 lb ft) . - Tighten temperature sensor (3) to a torque of
45 ± 5 N·m (33 ± 4 lb ft) - Tighten clamp assemblies (4) to a torque of
12 ± 1 N·m (106 ± 9 lb in) .
- Tighten clamp assembly (1) to a torque of
Caterpillar Information System:
C7.1 Marine Engine Connecting Rod Bearings - Remove and Install - Connecting rods in position
C7.1 Marine Engine Pistons and Connecting Rods - Assemble
C7.1 Marine Engine Pistons and Connecting Rods - Disassemble
C7.1 Marine Engine Pistons and Connecting Rods - Remove and Install
2013/02/27 A New Bracket Is Available for Certain C18 Marine Engines Equipped with Right Hand Service Duplex Fuel Filter Arrangements {1261}
3512B, 3512C, and 3516B Petroleum Engines and Petroleum Generator Set Engines with Dynamic Gas Blending Configuration Parameters
C18 Industrial Engine Injector Solenoid - Test
C32 Generator Set Declaration of Conformity
C11, C13, C15, and C18 Industrial Engines Ether Starting Aid - Test
C18 Industrial Engine Electrical Power Supply - Test
C18 Industrial Engine Data Link Configuration Status - Test
C18 Industrial Engine Coolant Level - Test
C9.3B Engines Flywheel Housing Cover
3500B Generator Set Engines Turbocharger
3500B Generator Set Engines Generator Coupling
3500B Generator Set Engines Generator Coupling
C4.4 Industrial Engine Alarms and Shutoffs
C27 Generator Set Declaration of Conformity
C7.1 Engines for Caterpillar Built Machines Gear Group (Front)
CG137 Engines Crank But Do Not Start{1000} CG137 Engines Crank But Do Not Start{1000}
C27 Generator Set Safety Messages
C280-16 Engine Model View Illustrations
NOx Sensors Handling and Installation Procedures {191N} NOx Sensors Handling and Installation Procedures {191N}
2013/02/11 Updating the Fuel Filter Group on Certain C27 and C32 Industrial Engines {1261, 1262}