Engine Oil Filter Base
Show/hide table
Illustration 1 | g03320431 |
Show/hide table
Specification for 381-9125 Oil Filter Base As | |||
Item | Qty | Part | Specification Description |
1 | 2 | 2P-4304 Hollow Stud | Apply red Loctite 271 on the tapered end of the hollow stud to the length of Torque to |
2 | 1 | 8C-3446 Fluid Sampling Valve | Installation torque is |
Caterpillar Information System:
CG137-08 and CG137-12 Generator Sets Turbocharger
CG137-08 and CG137-12 Generator Sets Valve Mechanism
CG137-08 and CG137-12 Generator Sets Valve Cover
CG137-08 and CG137-12 Generator Sets Gas Engine Ignition
CG137-08 and CG137-12 Generator Sets Air Cleaner
CG137-08 and CG137-12 Generator Sets Engine Oil Lines
CG137-08 and CG137-12 Generator Sets Camshaft
CG137-08 and CG137-12 Generator Sets Cylinder Block
CG137-08 and CG137-12 Generator Sets Water Pump
C175-16 Locomotive Engine Injector Solenoid - Test
C175-16 Locomotive Engine Fuel System Verification - Test
C175-16 Locomotive Engine Event Codes
CG137-08 and CG137-12 Generator Sets Crankcase Breather
CG137-08 and CG137-12 Generator Sets Engine Oil Pump
CG137-08 and CG137-12 Generator Sets Flywheel
C1.5 and C2.2 Industrial Engines Engine Temperature Sensor Open or Short Circuit - Test
CG137-08 and CG137-12 Generator Sets Vibration Damper and Pulley
CG137-08 and CG137-12 Generator Sets Air Starting Motor
CG137-08 and CG137-12 Generator Sets Gear Group (Front)
CG137-08 and CG137-12 Generator Sets Gear Group (Rear)
CG137-08 and CG137-12 Generator Sets Cylinder Head
3512B, 3512C, and 3516B Petroleum Engines and Petroleum Generator Set Engines with Dynamic Gas Blending Air Shutoff - Test
Procedure for Installing Object Detection Software on Monitor Display Group {7347, 7490, 7620} Procedure for Installing Object Detection Software on Monitor Display Group {7347, 7490, 7620}
C32 Marine Engines Sensor Signal (Analog, Active) - Test