CG137-08 and CG137-12 Generator Sets Caterpillar


Turbocharger

Usage:

CG137-08 FPL


Illustration 1g03320428

Table 1
Specification for 381-9113 Turbocharger Gp 
Item  Qty  Part  Specification Description 
7M-9918 Locknut  Use the following procedure to tighten the compressor housing clamp:
Before assembly, lubricate the threads with Loctite C5A Copper Anti-Seize.
1. Tighten the clamp locknut to 7.9 ± 2.0 N·m (69.9 ± 17.7 lb in).
2. Lightly tap the clamp all around.
3. Again, Tighten the clamp locknut to 10.5 ± 2.0 N·m (92.9 ± 17.7 lb in)
120-2244 Bolt  Before assembly, lubricate the threads with Loctite C5A Copper Anti-Seize.
Torque to 21.6 ± 5.0 N·m (191.2 ± 44.3 lb in)
2N-2766 Locknut  Before assembly, lubricate the threads with Loctite C5A Copper Anti-Seize.
Torque to 54 ± 5 N·m (40 ± 4 lb ft)

Caterpillar Information System:

CG137-08 and CG137-12 Generator Sets Valve Mechanism
CG137-08 and CG137-12 Generator Sets Valve Cover
CG137-08 and CG137-12 Generator Sets Gas Engine Ignition
CG137-08 and CG137-12 Generator Sets Air Cleaner
CG137-08 and CG137-12 Generator Sets Engine Oil Lines
CG137-08 and CG137-12 Generator Sets Camshaft
CG137-08 and CG137-12 Generator Sets Cylinder Block
CG137-08 and CG137-12 Generator Sets Water Pump
C175-16 Locomotive Engine Injector Solenoid - Test
C175-16 Locomotive Engine Fuel System Verification - Test
C175-16 Locomotive Engine Event Codes
C175-16 Locomotive Engine Diagnostic Trouble Codes
CG137-08 and CG137-12 Generator Sets Engine Oil Filter Base
CG137-08 and CG137-12 Generator Sets Crankcase Breather
CG137-08 and CG137-12 Generator Sets Engine Oil Pump
CG137-08 and CG137-12 Generator Sets Flywheel
C1.5 and C2.2 Industrial Engines Engine Temperature Sensor Open or Short Circuit - Test
CG137-08 and CG137-12 Generator Sets Vibration Damper and Pulley
CG137-08 and CG137-12 Generator Sets Air Starting Motor
CG137-08 and CG137-12 Generator Sets Gear Group (Front)
CG137-08 and CG137-12 Generator Sets Gear Group (Rear)
CG137-08 and CG137-12 Generator Sets Cylinder Head
3512B, 3512C, and 3516B Petroleum Engines and Petroleum Generator Set Engines with Dynamic Gas Blending Air Shutoff - Test
Procedure for Installing Object Detection Software on Monitor Display Group {7347, 7490, 7620} Procedure for Installing Object Detection Software on Monitor Display Group {7347, 7490, 7620}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.