Piston Cooling Jets - Remove and Install
Start By:
- Remove the engine oil pump, if necessary. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove the cylinder block cover from the side of the engine.
Show/hide table
Illustration 1 g00913178 Show/hide tableIllustration 2 g00913185 - Remove bolts (1) and retainer (2).
- Remove piston cooling jet (3) from the inside of the engine.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position piston cooling jet (3) in the engine block. Ensure that the oil holes in the end of the jet are facing toward the piston.
- Install retainer (2) and bolts (1).
- Install the cylinder block cover on the side of the engine.
Show/hide table
Illustration 3 | g00913185 |
Show/hide table
Illustration 4 | g00913178 |
End By:
- Install the engine oil pump, if necessary. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".
Caterpillar Information System:
3516B Engine Gear Group (Rear) - Install
C175-16 and C175-20 Generator Set Engines Turbocharger
2012/12/10 A Revised Application and Installation Guide Is Now Available for Certain Industrial Engines {1000}
C175-16 and C175-20 Generator Set Engines Turbocharger
C175-16 and C175-20 Generator Set Engines Turbocharger
C175-16 and C175-20 Generator Set Engines Turbocharger
C175-16 and C175-20 Generator Set Engines Engine Oil Pan
C175-16 and C175-20 Generator Set Engines Engine Oil Pan
C32 Auxiliary Engine Control Panel - Cat Marine Engine Control Panel I (MECP I) (If Equipped)
G3500H 60Hz Generator Sets Spark Plugs - Inspect/Adjust/Replace
3516B Engine Gear Group (Rear) - Remove
3516B Engine Engine Oil Sequence Valves - Remove and Install
3516B Engine Bearing Clearance - Check
3516B Engine Connecting Rod Bearings - Remove and Install
3516B Engine Crankshaft Main Bearings - Remove
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Wiring Harness (Open Circuit) - Test
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Wiring Harness (Short Circuit) - Test
C18 Marine Engine Configuration Parameters
349F and 352F Excavators ECM Software - Install
349F and 352F Excavators ECM - Configure
C18 Marine Auxiliary and Marine Generator Set Engines Exhaust Has Excessive White Smoke
C175-16 and C175-20 Generator Set Engines Pressure Control Valve - Oil Regulator Valve and Oil Bypass Valve
C175-16 and C175-20 Generator Set Engines Engine Oil Pan
C175-16 and C175-20 Generator Set Engines Oil Pump