Engine Oil Pan
Show/hide table
Illustration 1 | g03176899 |
Show/hide table
Specification for 293-4999 Oil Pan Gp | |||
Item | Qty | Part | Specification Description |
1 | 2 | 269-7886 O-Ring Seal | Before assembly, apply 5P-3975 Rubber Lubricant to the bores. |
2 | 4 | 6V-3835 O-Ring Seal | Before assembly, apply 5P-3975 Rubber Lubricant to the bores. |
- | - | - | Before assembly, apply Loctite RTV Silicone Clear and Permatex No. 2 to the gasket joints and the joints between the housing and the block face. |
Caterpillar Information System:
C175-16 and C175-20 Generator Set Engines Pressure Control Valve - Oil Regulator Valve and Oil Bypass Valve
C18 Marine Auxiliary and Marine Generator Set Engines Exhaust Has Excessive White Smoke
349F and 352F Excavators ECM - Configure
349F and 352F Excavators ECM Software - Install
C18 Marine Engine Configuration Parameters
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Wiring Harness (Short Circuit) - Test
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Wiring Harness (Open Circuit) - Test
3516B Engine Crankshaft Main Bearings - Remove
3516B Engine Connecting Rod Bearings - Remove and Install
3516B Engine Bearing Clearance - Check
3516B Engine Piston Cooling Jets - Remove and Install
3516B Engine Gear Group (Rear) - Install
C175-16 and C175-20 Generator Set Engines Oil Pump
C175-16 and C175-20 Generator Set Engines Air Lines
C175-16 Locomotive Engine Water Pump
C175-16 Locomotive Engine Air Lines
C175-16 and C175-20 Generator Set Engines Flywheel
CEM Locomotive Aftertreatment Overhaul (Top End)
3516C Locomotive Engine and Generator Set Overhaul (In-Frame)
3516C Locomotive Engine and Generator Set Flexible Coupling Oil - Change - If Equipped
C175-16 and C175-20 Generator Set Engines Flywheel
C175-16 Locomotive Engine Pressure Sensor
Cat Water Delivery System (WDS) Fuses - Replace
Cat Water Delivery System (WDS) Hydraulic Oil Cooler - Clean