Turbocharger
Show/hide table
| |
| Illustration 1 | g03175516 |
Show/hide table
| Specification for 293-3540 Turbocharger Gp | |||
| Item | Qty | Part | Specification Description |
| 1 | 2 | 330-9746 Connector As | Before assembly, apply black Loctite Gasket Maker #2 to the threads. |
| 2 | 24 | 293-5490 Bolt | Before assembly, lubricate the threads with Loctite C5A copper anti-seize.
Tighten clamp plate bolts to |
| 3 | 2 | 372-5858 Band Clamp | Use the following procedure in order to tighten the turbine clamp assembly: Before assembly, lubricate the threads with Loctite C5A copper anti-seize. 1. Tighten first nut of the band clamp to 17 turns, such that approximately 2. Tighten second nut of the band clamp to 3. Tighten first nut of the band clamp to 4. Gently hit around the band clamp assembly with a soft hammer. 5. Again, tighten first nut of the band clamp to 6. Again, tighten second nut of the band clamp to 7. Again, gently hit around the clamp assembly with a soft hammer. 8. Again, tighten both the nut of the band clamp assembly to |
Caterpillar Information System:
C175-16 and C175-20 Generator Set Engines Turbocharger
C175-16 and C175-20 Generator Set Engines Engine Oil Pan
C175-16 and C175-20 Generator Set Engines Engine Oil Pan
C32 Auxiliary Engine Control Panel - Cat Marine Engine Control Panel I (MECP I) (If Equipped)
G3500H 60Hz Generator Sets Spark Plugs - Inspect/Adjust/Replace
3516B Engine Gear Group (Rear) - Remove
3516B Engine Engine Oil Sequence Valves - Remove and Install
C18 Marine Engines Engine Stalls at Low RPM
3516B Engine Flywheel Housing - Remove
Reusability Guidelines for Single Tooth Master Links {0729, 4150, 4169, 4171} Reusability Guidelines for Single Tooth Master Links {0729, 4150, 4169, 4171}
3516B Engine Flywheel - Remove and Install
3516B Engine Crankshaft Front Seal and Wear Sleeve - Install
C175-16 and C175-20 Generator Set Engines Turbocharger
2012/12/10 A Revised Application and Installation Guide Is Now Available for Certain Industrial Engines {1000}
C175-16 and C175-20 Generator Set Engines Turbocharger
3516B Engine Gear Group (Rear) - Install
3516B Engine Piston Cooling Jets - Remove and Install
3516B Engine Bearing Clearance - Check
3516B Engine Connecting Rod Bearings - Remove and Install
3516B Engine Crankshaft Main Bearings - Remove
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Wiring Harness (Open Circuit) - Test
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Wiring Harness (Short Circuit) - Test
C18 Marine Engine Configuration Parameters
349F and 352F Excavators ECM Software - Install