Turbocharger
Show/hide table
Illustration 1 | g03175816 |
Left side view of engine |
Show/hide table
Specification for 258-8009 Turbocharger Gp | |||
Item | Qty | Part | Specification Description |
1 | 4 | 330-9744 Connector As | Before assembly, apply black Loctite Gasket Maker #2 to the threads. |
2 | 4 | 283-4294 Clamp As | Use the following procedure in order to tighten the turbine clamp assembly: Before assembly, lubricate the threads with Loctite C5A copper anti-seize. 1. Tighten nut of the clamp assembly to 2. Gently hit around the clamp assembly with a soft hammer. 3. Again, tighten nut of the clamp assembly to 4. Again, gently hit around the clamp assembly with a soft hammer. 5. Again, tighten nut of the clamp assembly to |
3 | 40 | 287-7200 Bolt | Before assembly, lubricate the threads with Loctite C5A copper anti-seize.
Tighten clamp plate bolts to |
Caterpillar Information System:
2012/12/10 A Revised Application and Installation Guide Is Now Available for Certain Industrial Engines {1000}
C175-16 and C175-20 Generator Set Engines Turbocharger
C175-16 and C175-20 Generator Set Engines Turbocharger
C175-16 and C175-20 Generator Set Engines Turbocharger
C175-16 and C175-20 Generator Set Engines Engine Oil Pan
C175-16 and C175-20 Generator Set Engines Engine Oil Pan
C32 Auxiliary Engine Control Panel - Cat Marine Engine Control Panel I (MECP I) (If Equipped)
G3500H 60Hz Generator Sets Spark Plugs - Inspect/Adjust/Replace
3516B Engine Gear Group (Rear) - Remove
3516B Engine Engine Oil Sequence Valves - Remove and Install
C18 Marine Engines Engine Stalls at Low RPM
3516B Engine Flywheel Housing - Remove
3516B Engine Gear Group (Rear) - Install
3516B Engine Piston Cooling Jets - Remove and Install
3516B Engine Bearing Clearance - Check
3516B Engine Connecting Rod Bearings - Remove and Install
3516B Engine Crankshaft Main Bearings - Remove
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Wiring Harness (Open Circuit) - Test
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Wiring Harness (Short Circuit) - Test
C18 Marine Engine Configuration Parameters
349F and 352F Excavators ECM Software - Install
349F and 352F Excavators ECM - Configure
C18 Marine Auxiliary and Marine Generator Set Engines Exhaust Has Excessive White Smoke
C175-16 and C175-20 Generator Set Engines Pressure Control Valve - Oil Regulator Valve and Oil Bypass Valve