Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
Show/hide table
| |
| 图 1 | g02841080 |
|
右视图 | |
Show/hide table
| |
| 图 2 | g02557496 |
|
前视图 | |
Show/hide table
| 技术规格 - 273-7582 发动机机油滤清器总成和 286-5749 发动机机油滤清器总成 | |||
| 项目 | 数量 | 零件 | 技术规格说明 |
| 1 | 2 | 4F-8965 螺栓 | 按照以下步骤拧紧卡箍螺栓：
1. 将卡箍组件拧紧到管上。 2. 将卡箍组件拧紧到弯管上。 3. 将卡箍组件拧紧到管上。 |
| 2 | 4 | 0S-1571 螺栓 | |
| 6 | 2 | 0S-1594 螺栓 | |
| 3 | 2 | 237-7623 O 形密封圈 | 组装前，用密封的液体稍稍润滑孔。 |
| 4 | 2 | 7N-7697 柱塞 | 阀必须在 阀必须在 |
| 5 | 2 | 6B-9202 弹簧 | 测试力下的长度为 |
| 测试力为 |
|||
| 测试后的自由长度为 |
|||
| 7 | 3 | 109-2332 O 形密封圈 | 组装前，用密封的液体稍稍润滑孔。 |
| 8 | 3 | 7G-6713 弹簧 | 测试力下的长度为 |
| 测试力为 |
|||
| 测试后的自由长度为 |
|||
| 9 | 3 | 1P-1367 柱塞 | 阀必须在孔中自由移动。
发动机操作期间，阀必须在 |
| 10 | 1 | 2W-1053 塞 | 拧紧至扭矩为 |
| 11 | 1 | 124-4273 旁通阀 | 阀必须在 |
| 12 | 1 | 2W-1635 弹簧 | 测试力下的长度为 |
| 测试力为 |
|||
| 测试后的自由长度为 |
|||
Caterpillar Information System:
3500B Engines for Caterpillar Built Power Modules Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
C175-16 Locomotive Engine Cylinder Head Valves
CG137-08 and CG137-12 Engines Plate Locations and Film Locations
Network Management Card and Network Management Card with Environmental Monitoring for the UPSB505 Uninterruptible Power Supply Environmental Monitoring
Network Management Card and Network Management Card with Environmental Monitoring for the UPSB505 Uninterruptible Power Supply UPS Monitor and Configure
3516C Generator Set Engines Intake Manifold Air Temperature Is High
C13, C15, and C18 Tier 4 Final Engines Flywheel
Blow-by from Crankcase Breather for C2.2, C3.3, C4.4, C6.6, C7.1 (Mechanical), and C7.1 Engines {1000, 1074, 1107, 1317} Blow-by from Crankcase Breather for C2.2, C3.3, C4.4, C6.6, C7.1 (Mechanical), and C7.1 Engines {1000, 1074, 1107, 1317}
C13, C15, and C18 Tier 4 Final Engines Flywheel
C13, C15, and C18 Tier 4 Final Engines Flywheel
3500 Engines Air Shutoff
C9.3 Tier 4 Final Engines Exhaust Diffuser Adapter
C13, C15, and C18 Tier 4 Final Engines Speed/Timing Sensor
C13 Tier 4 Final Engines Solenoid Valve - Air Control Valve Gp
C13, C15, and C18 Tier 4 Final Engines Speed/Timing Sensor
Additional Procedure when Replacing the Engine, ECM, or CEM Tier 4 Engines{1000, 108D, 108F, 1901} Additional Procedure when Replacing the Engine, ECM, or CEM Tier 4 Engines{1000, 108D, 108F, 1901}
XQ125 Generator Set Fuel Tank Water and Sediment - Drain
CG137-08 and CG137-12 Engines Product Lifting
UPSB505 Uninterruptible Power Supply UPS Battery - 50Hz General Information
2011/08/26 A New Wiring Harness Is Used On Certain Commercial Engines {1408, 1900}
3516C IMO III Petroleum Engines Engine Oil Cooler - Remove
UPSB505 Uninterruptible Power Supply UPS Battery - 50Hz Component Location
C15 and C18 Industrial Engines Electric Starting Motor
3500 Engines Engine Oil Filter