3500B Engines for Caterpillar Built Power Modules Caterpillar


Engine Oil Cooler Bypass and Cooling Jet Sequence Valves

Usage:

3516B BCK


图 1g01616336
右视图
典型示例


图 2g02557456
前视图
典型示例

表 1
技术规格 - 115-7860 发动机油管路总成、 202-2657 发动机油管路总成和 262-0338 发动机油管路总成 
项目  数量  零件  技术规格说明 
0S-1594 螺栓  按下列顺序拧紧卡箍螺栓:
1. 将卡箍组件 (3) 紧密地紧固至管 (4)。
2. 将卡箍组件的两个螺栓 (2) 拧紧到弯头 (9) 至扭矩 47 ± 9 N·m (35 ± 7 lb ft)
3. 将卡箍组件的两个螺栓 (1) 拧紧到管 (4) 至扭矩 47 ± 9 N·m (35 ± 7 lb ft)。 
0S-1571 螺栓 
冷却喷嘴管顺序阀必须在 130 ± 30 kPa (19 ± 4 psi) 的压差下开始开启。
冷却喷嘴管顺序阀必须在 200 ± 30 kPa (29 ± 4 psi) 的压差下完全开启。 
6B-9202 弹簧  测试力下的长度为 68.3 mm (2.69 inch)
测试力为 85 to 100 N (19 to 22 lb)
测试后的自由长度为 112.7 mm (4.44 inch)。 
2W-1635 弹簧  测试力下的长度为 102.0 mm (4.02 inch)
测试力为 518 ± 26 N (116 ± 6 lb)
测试后的自由长度为 143.4 mm (5.65 inch)
机油冷却器旁通阀必须在 180 ± 20 kPa (26 ± 3 psi) 的压差下开启。 
109-2332 O 形密封圈  用清洁的发动机机油稍稍润滑孔。 
2W-1053 塞  拧紧至扭矩为 100 ± 15 N·m (74 ± 11 lb ft)。 

Caterpillar Information System:

C175-16 Locomotive Engine Cylinder Head Valves
CG137-08 and CG137-12 Engines Plate Locations and Film Locations
Network Management Card and Network Management Card with Environmental Monitoring for the UPSB505 Uninterruptible Power Supply Environmental Monitoring
Network Management Card and Network Management Card with Environmental Monitoring for the UPSB505 Uninterruptible Power Supply UPS Monitor and Configure
3516C Generator Set Engines Intake Manifold Air Temperature Is High
C13, C15, and C18 Tier 4 Final Engines Flywheel
Blow-by from Crankcase Breather for C2.2, C3.3, C4.4, C6.6, C7.1 (Mechanical), and C7.1 Engines {1000, 1074, 1107, 1317} Blow-by from Crankcase Breather for C2.2, C3.3, C4.4, C6.6, C7.1 (Mechanical), and C7.1 Engines {1000, 1074, 1107, 1317}
C13, C15, and C18 Tier 4 Final Engines Flywheel
C13, C15, and C18 Tier 4 Final Engines Flywheel
3500 Engines Air Shutoff
C9.3 Tier 4 Final Engines Exhaust Diffuser Adapter
C13, C15, and C18 Tier 4 Final Engines Flywheel
3500 Engines Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
C13, C15, and C18 Tier 4 Final Engines Speed/Timing Sensor
C13 Tier 4 Final Engines Solenoid Valve - Air Control Valve Gp
C13, C15, and C18 Tier 4 Final Engines Speed/Timing Sensor
Additional Procedure when Replacing the Engine, ECM, or CEM Tier 4 Engines{1000, 108D, 108F, 1901} Additional Procedure when Replacing the Engine, ECM, or CEM Tier 4 Engines{1000, 108D, 108F, 1901}
XQ125 Generator Set Fuel Tank Water and Sediment - Drain
CG137-08 and CG137-12 Engines Product Lifting
UPSB505 Uninterruptible Power Supply UPS Battery - 50Hz General Information
2011/08/26 A New Wiring Harness Is Used On Certain Commercial Engines {1408, 1900}
3516C IMO III Petroleum Engines Engine Oil Cooler - Remove
UPSB505 Uninterruptible Power Supply UPS Battery - 50Hz Component Location
C15 and C18 Industrial Engines Electric Starting Motor
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.