Inlet Air Temperature Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (2).
- Remove inlet air temperature sensor (1) from the cylinder head.
- Remove the O-ring seal from the inlet air temperature sensor.
Show/hide table
Illustration 1 | g02473740 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new O-ring seal on the inlet air temperature sensor.
- Install inlet air temperature sensor (1) and tighten to a torque of
20 ± 5 N·m (15 ± 4 lb ft) . - Connect harness assembly (2).
Show/hide table
Illustration 2 | g02473740 |
Caterpillar Information System:
C15 Petroleum Engines Turbocharger Outlet Pressure Sensor - Remove and Install
C15 Petroleum Engines Fuel Temperature Sensor - Remove and Install
C15 Petroleum Engines Fuel Pressure Sensor - Remove and Install
C15 Petroleum Engines Engine Oil Pressure Sensor - Remove and Install
C15 Petroleum Generator Set Reference Material
C15 Petroleum Engines Diagnostic Flash Code Retrieval
C15 Petroleum Engines Camshaft Position Sensor - Remove and Install
C15 Petroleum Engines Atmospheric Pressure Sensor - Remove and Install
C15 Petroleum Engines Control Panel
CX31 On-Highway Transmission Oil Filter (Transmission)
Do Not Use Loctite Moly Paste 51049 on Critical Fasteners{0645} Do Not Use Loctite Moly Paste 51049 on Critical Fasteners{0645}
C15 Petroleum Generator Set Safety Messages
9U-7840 Fuel Injection Equipment Calibration Fluid Test Kit{0374, 0599, 0706} 9U-7840 Fuel Injection Equipment Calibration Fluid Test Kit{0374, 0599, 0706}
G3304B and G3306B Engines Safety Messages
2011/03/21 Power to the Fuel Control Module Is Now Supplied by the Engine Electronic Control Module (ECM) on C175-16 Generator Sets {1000, 1900}
323-1146 C-175 Engine Lifting Bracket{0599, 0629, 0701, 1000, 1122} 323-1146 C-175 Engine Lifting Bracket{0599, 0629, 0701, 1000, 1122}
C18 Generator Set Engine Speed/Timing Sensor - Clean/Inspect
C13, C15, and C18 Tier 4 Interim Engines Shutdown - Test
G3304B and G3306B Engines Plate Locations and Film Locations
G3304B and G3306B Engines Overhaul (Top End)
UPSB130 Uninterruptible Power Supply UPS Battery - 60Hz IGBT - Test
G3304B and G3306B Engines Ignition System Timing - Check/Adjust
C27 and C32 Industrial Engines Product Description
C32 Petroleum Engines Refill Capacities