Atmospheric Pressure Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (1).
- Remove atmospheric pressure sensor (2) from the adapter on the cylinder block.
- Remove the O-ring seal from the atmospheric pressure sensor.
Show/hide table
Illustration 1 | g02472898 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new O-ring seal on the atmospheric pressure sensor.
- Install atmospheric pressure sensor (2) and tighten to a torque of
10 ± 2 N·m (89 ± 18 lb in) . - Connect harness assembly (1).
Show/hide table
Illustration 2 | g02472898 |
Caterpillar Information System:
C15 Petroleum Engines Control Panel
CX31 On-Highway Transmission Oil Filter (Transmission)
Do Not Use Loctite Moly Paste 51049 on Critical Fasteners{0645} Do Not Use Loctite Moly Paste 51049 on Critical Fasteners{0645}
C15 Petroleum Generator Set Safety Messages
UPSB505 Uninterruptible Power Supply UPS Isolation
UPSB130 Uninterruptible Power Supply Safety Signs and Labels
PM3516 Power Modules Specifications
UPS 1000Z, UPS 1200Z, UPS500G and UPS600G Uninterruptible Power Supplys Error Log - Access
C15 Petroleum Engines Event Codes
2011/03/21 Engine Air Cleaner Service Indicator on Certain C4.4 Generator Sets {1051, 1054, 7452}
Risk of High-Pressure Water Entering The Service Tool Connector on 3500B Locomotive Engines{0785, 1408} Risk of High-Pressure Water Entering The Service Tool Connector on 3500B Locomotive Engines{0785, 1408}
CX31 and CX31 HT On-Highway Transmissions Torque Converter
C15 Petroleum Engines Camshaft Position Sensor - Remove and Install
C15 Petroleum Engines Diagnostic Flash Code Retrieval
C15 Petroleum Generator Set Reference Material
C15 Petroleum Engines Engine Oil Pressure Sensor - Remove and Install
C15 Petroleum Engines Fuel Pressure Sensor - Remove and Install
C15 Petroleum Engines Fuel Temperature Sensor - Remove and Install
C15 Petroleum Engines Turbocharger Outlet Pressure Sensor - Remove and Install
C15 Petroleum Engines Inlet Air Temperature Sensor - Remove and Install
9U-7840 Fuel Injection Equipment Calibration Fluid Test Kit{0374, 0599, 0706} 9U-7840 Fuel Injection Equipment Calibration Fluid Test Kit{0374, 0599, 0706}
G3304B and G3306B Engines Safety Messages
2011/03/21 Power to the Fuel Control Module Is Now Supplied by the Engine Electronic Control Module (ECM) on C175-16 Generator Sets {1000, 1900}
323-1146 C-175 Engine Lifting Bracket{0599, 0629, 0701, 1000, 1122} 323-1146 C-175 Engine Lifting Bracket{0599, 0629, 0701, 1000, 1122}