Engine Description
The Cat C15 Industrial Engine provides the following features:
- Four-stroke cycle
- Mechanically actuated electronically controlled fuel injection system
- Turbocharged
Engine Specifications
Note: The front end of the engine is opposite the flywheel end of the engine. The left and the right sides of the engine are determined from the flywheel end. The number 1 cylinder is the front cylinder.
 | |
| Illustration 1 | g01387009 |
Cylinder and valve location (A) Exhaust valve (B) Inlet valve | |
| C15 Engine Specifications | ||
| Arrangement and Cylinders | In line 6 cylinder | |
| Bore | 137 mm (5.4 inch) | |
| Stroke | 171 mm (6.7 inch) |
|
| Aspiration | ATAAC (1) | |
| Displacement | 15.2 L (928 cubic inch) |
|
| Firing Order | 1-5-3-6-2-4 | |
| Rotation (flywheel end) | Counterclockwise | |
| ( 1 ) | Air-to-air aftercooled |
Electronic Engine Features
The Cat C15 Engine is designed for electronic controls. The integral on board computer controls the operation of the engine. Current operating conditions are monitored. The Electronic Control Module (ECM) controls the response of the engine to these conditions and to the demands of the operator. These conditions and operator demands determine the precise control of fuel injection by the ECM. The electronic engine control system provides the following features:
- Engine speed governor
- Automatic air/fuel ratio control
- Torque rise shaping
- Injection timing control
- System diagnostics
- NOx reduction system control
Additional Features
The following additional features provide increased engine fuel economy and serviceability:
- Cold starting capability
- Tampering detection
- Diagnostics
Engine Diagnostics
The engine has built-in diagnostics in order to ensure that all of the components are functioning properly. Under certain conditions, the engine horsepower and the vehicle speed may be limited. A Cat electronic service tool may be used to display the diagnostic code.
There are two categories of codes: diagnostic code and event code. These two categories of codes may be in two different states: active and logged.
Most of the diagnostic codes are logged and stored in the ECM. For additional information, refer to the Operation and Maintenance Manual, "Engine Diagnostics" topic (Operation Section).
Engine Service Life
Engine efficiency and maximum utilization of engine performance depend on the adherence to proper operation and maintenance recommendations. In addition, use recommended fuels, coolants, and lubricants. Use the Operation and Maintenance Manual as a guide for required engine maintenance.
Expected engine life is predicted by the average power that is demanded. The average power that is demanded is based on fuel consumption of the engine over a time. Reduced hours of operation at full throttle and/or operating at reduced throttle settings result in a lower average power demand. Reduced hours of operation will increase the length of operating time before an engine overhaul is required. For more information, refer to the Operation and Maintenance Manual, "Overhaul Considerations" topic (Maintenance Section).
Aftermarket Products and Cat Engines
| NOTICE |
|---|
In order to maximize fuel system life and prevent premature wear out from abrasive particles in the fuel, a four micron[c] absolute high efficiency fuel filter is required for all Caterpillar common rail fuel systems. Caterpillar High Efficiency Fuel Filters meet these requirements. Consult your Caterpillar dealer for the proper part numbers. |
The Caterpillar warranty is not affected by the use of auxiliary devices, accessories, or consumables which are made by other manufacturers.
However, failures that result from the installation or use of devices, accessories, or consumables from other manufacturers are NOT Caterpillar defects. Therefore, the defects are NOT covered under the Caterpillar warranty.