Grounding Stud - Inspect/Clean/Tighten
Show/hide table
 | |
| Illustration 1 | g00768411 |
Typical example | |
Inspect the OEM harness for good connections and condition.
The electrical grounding stud must have a wire ground to the battery. Tighten the electrical grounding stud at every oil change. Refer to Specifications, SENR3130 for the correct torque. Ground wires and straps should be combined at engine grounds. All grounds should be tight and free of corrosion.
- If the connections are corroded, clean the connections with a solution of baking soda and water.
- Keep the electrical grounding stud and the strap clean and coated with MPGM grease or petroleum jelly.
Caterpillar Information System:
Cat® Grade Control Depth & Slope for E-Series and F-Series Excavators Machine Monitoring System Configuration
Cat® Grade Control Depth & Slope for E-Series and F-Series Excavators Grade Control Configuration
Contamination Control of Rebuilt Engines by Using a Particle Counting Process Patent Pending{1000, 1300} Contamination Control of Rebuilt Engines by Using a Particle Counting Process Patent Pending{1000, 1300}
2011/01/10 A New Waste Gate for the Turbocharger Is Now Being Used on the Certain C13 Industrial Engines {1052, 1053, 1057, 1940}
3500 Engines Engine Oil Sequence Valves - Remove and Install
349F and 352F Excavators Machine System Specifications Accumulator (Pilot)
349F and 352F Excavators Machine System Specifications Relief Valve (Main)
349F and 352F Excavators Machine System Specifications Check Valve
Training Materials {0314, 0374, 4150} Training Materials {0314, 0374, 4150}
CX31 On-Highway Transmission Retarder - Install
3516C Locomotive Engines Flywheel Housing - Install
CX31 On-Highway Transmission Retarder - Remove
349F and 352F Excavators Hydraulic System Relief Valve (Counterweight Cylinder) - Test and Adjust
C7 Engines for Combat and Tactical Vehicles Severe Service Application
3406E and C15 Marine Engines Fuel Injector - Check
Filtration Procedure for Rebuilt Engines {0680, 0768, 1000, 1300} Filtration Procedure for Rebuilt Engines {0680, 0768, 1000, 1300}
349F and 352F Excavators Machine System Specifications Check Valve (Return Lines)
349F and 352F Excavators Machine System Specifications Pump Lines (Main)
349F and 352F Excavators Machine System Specifications Boom Cylinder Lines
Suggested Equipment Layouts {0374, 0729, 4150, 7000, 7950} Suggested Equipment Layouts {0374, 0729, 4150, 7000, 7950}
349F and 352F Excavators Machine System Specifications Stick Cylinder Lines
2011/01/10 A New Valve Bridge Is Available for Certain Commercial Engines {1102, 1123}
349F and 352F Excavators Machine System Specifications Control Valve (Auxiliary)
2011/01/10 A New Valve Bridge Is Available for Certain Truck Engines {1102, 1123}