Crankshaft
Show/hide table
图 1 | g02563497 |
(2) 连杆轴承轴颈 (3) 主轴承轴颈 |
Show/hide table
361-5593 曲轴总成 的技术规格     | |||
项目     | 数量     | 零件     | 技术规格说明     |
1     | 2     | 246-3144 止推片     | 止推片只可用于中央主轴承轴颈上。     |
A     | -     | -     | 曲轴齿轮和曲轴之间的间隙不应超过 0.10 mm (0.004 in)。     |
B     | -     | -     | 曲轴齿轮的平均直径为 136.25 ± 0.11 mm (5.364 ± 0.004 in)。 组装后曲轴齿轮的最大直径为 136.38 mm (5.369 in)。     |
D     | -     | -     | 定位销 (4) 顶部至曲轴表面的高度为 8.0 ± 0.5 mm (0.31 ± 0.02 in)。     |
-     | -     | -     | 在将曲轴装配到缸体中后,曲轴端隙最大应为 0.50 mm (0.020 in),最小应为 0.10 mm (0.004 in)。     |
Caterpillar Information System:
C15 and C18 Petroleum Generator Sets Severe Service Application
G3520E Generator Set Engines Integrated Temperature Sensing Module - Test
G3520E Generator Set Engines Generator Output Power - Test
G3520E Generator Set Engines Fuel Metering Valve - Test
3508C, 3512C and 3516C Locomotive Engines Cylinder Block
320E and 323E Excavators Machine System Specifications Travel Counterbalance Valve
C27 and C32 Generator Set Engines Electric Starting Motor
3500 Engines Engine Oil Pan - Install
C13, C15, and C18 Tier 4 Final Engines Water Pump
Modifying the Turbocharger Group on Certain 3500 Marine Engines and 797 and 797B Off-Highway Trucks{1052, 1053} Modifying the Turbocharger Group on Certain 3500 Marine Engines and 797 and 797B Off-Highway Trucks{1052, 1053}
2010/11/01 New Tube Assembly Is Used for Low-Pressure Return Lines on C175 Generator Set Engines {1252, 1254}
CX28 On-Highway Transmission Transfer Gear and Case - Assemble
G3520E Generator Set Engines Event Codes
349F and 352F Excavators Machine System Specifications Shuttle Valve (Pilot Lines)
C3.4B Industrial Engine High Pressure Fuel Lines
C3.4B Industrial Engine Electrical System
C7.1 Industrial Engine and Generator Set Intake Manifold Air Pressure Is High
XQ175 Rental Generator Set Product Description
C13 Engines for Caterpillar Built Machines Relay (ARD Nozzle Heater) - Remove and Install - Clean Emissions Module
C13, C15, and C18 Tier 4 Final Engines Gear Group (Front)
Procedure to Machine Damaged Transmission and Differential Yokes {3030, 3253, 3258} Procedure to Machine Damaged Transmission and Differential Yokes {3030, 3253, 3258}
C3.4B Industrial Engine Model View Illustrations
C13, C15, and C18 Tier 4 Final Engines Flywheel Housing
793F and 793F CMD Off-Highway Truck Power Train Air Inlet System - Test and Inspect