C7.1 (Mech) Industrial Engine Caterpillar


Fuel System Pressure - Test

Usage:

C7.1 630

  • 从输油泵上断开燃油出口管。

  • 安装一个压力表,用于测量输油泵出口的压力(最大可达 70 kPa (10 psi))。

  • 松开压力表的接头,操作输油泵的充注杆,从管中排出空气。

  • 当不含空气的燃油从管中流出时,拧紧接头。 确保油泵和压力表之间的接头没有渗漏。

  • 在发动机停机控制装置处于停机位置时,或停机电磁阀断开时,运行启动电机 10 秒钟。

  • 如果压力表所示压力小于 26 kPa (3.77 psi),则需要维修或更换输油泵。

  • 检查压力减小到最大压力值一半的速率。 如果小于 30 秒,则需维修或更换输油泵。

  • 拆下压力表,将出口管连接到输油泵上。

  • 松开燃油滤清器头部的排气螺钉。 操作充注杆,直至不含空气的燃油从排气螺钉流出。 拧紧排气螺钉。

  • 连接发动机停机电磁阀。

  • Back to top
    The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
    CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.