Coolant Temperature Sensor - Remove and Install
- Drain the coolant from the cooling system to a level below the coolant temperature sensor into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct draining and filling procedures.
Show/hide table
Illustration 1 g02252733 - Disconnect hose assemblies (1) and (2).
- Remove bolts (4) and position manifold (3) out of the way.
- Remove bolts (5) and remove bracket (6).
Show/hide table
Illustration 2 g02257094 - Disconnect harness assembly (7) and remove coolant temperature sensor (8).
- Install coolant temperature sensor (8) in reverse order of removal.
- Install a new O-ring seal on coolant temperature sensor (8).
- Install coolant temperature sensor (8) and tighten to a torque of
20 ± 3 N·m (177 ± 27 lb in) .
- Install coolant temperature sensor (8) and tighten to a torque of
Caterpillar Information System:
120 and 120 AWD Motor Grader Scarifier Digging Angle - If Equipped
2012/06/29 A New Engine Oil Filter Element Is Used for Certain C175-16 Engines {1306, 1308}
G3304B and G3306B Engines Cover Group (Front Housing)
C27 and C32 Engines for Caterpillar Built Machines Crankshaft Position Sensor - Remove and Install
C9.3 Tier 4 Interim Engines Diesel Particulate Filter Temperature Is High
2010/08/23 Use Proper Procedures with Speed/Timing Sensor Diagnostic Codes for C175 Generator Set Engines {1408, 1439, 1912}
3512C HD Locomotive Engine Cooling System Coolant (DEAC) - Change
3512C HD Locomotive Engine Belts - Inspect/Adjust/Replace
C27 Generator Set Overhaul Considerations
2010/09/17 New Silicone Power Cables Are Now Used For Power Connections On Certain Cat Generator Sets {1408, 4460}
3512C HD Locomotive Engine Engine Oil Level - Check
3512C HD Locomotive Engine After Stopping Engine
120 and 120 AWD Motor Grader Axle Oscillation Bearings - Lubricate
120 and 120 AWD Motor Grader Drawbar Ball and Socket - Lubricate
3512C Oil Well Service Engines Safety Messages
2011/01/10 A New Wiring Harness Kit Is Available in Order to Make Repairs on Certain Truck Engines {1254, 1290, 1408}
2010/12/06 A New Injector Wiring Harness Kit Is Available to Make Repairs on Certain Commercial Engines {1254, 1290, 1408}
120 and 120 AWD Motor Grader Drawbar Ball and Socket End Play - Check/Adjust
3512C Oil Well Service Engines Product Lifting
3516C Locomotive Engines Selective Catalytic Reduction Module - Disassemble
XQ Auto Paralleling Initial Startup Procedure
XQ Auto Paralleling Installation
XQ Auto Paralleling Handling
XQ Auto Paralleling Generator Load Connections