Grounding Stud - Inspect/Clean/Tighten
Show/hide table
Ilustrace 1 | g01376112 |
Zemnicí kolík se nachází na levém horním rohu řídicího modulu motoru. |
Zkontrolujte, zda jsou spojení svazku vodičů OEM v dobrém stavu. Prověřte stav svazku vodičů OEM.
Zemnicí kolík musí být vybaven vedením k uzemnění akumulátoru. Utáhněte zemnicí kolík při každé výměně oleje. Zemnicí vodiče a pásky musí být v oblasti uzemnění motoru spojeny. Všechny zemnicí prvky musí být dobře utažené a nesmí vykazovat stopy koroze.
- Očistěte zemnicí kolík a svorky zemnicího pásku čistým hadrem.
- Pokud jsou spojení zkorodovaná, vyčistěte je pomocí roztoku jedlé sody a vody.
- Udržujte zemnicí kolík a pásek čisté a pokryté tenkou vrstvou maziva MPGM nebo vazelíny.
Caterpillar Information System:
Rework Procedure for the Connection of Engine Harness to Engine Interface Module (EIM) Fitted to Certain C2.2, C3.3, C4.4, and C6.6 Powered Generating Sets{1901, 7451} Rework Procedure for the Connection of Engine Harness to Engine Interface Module (EIM) Fitted to Certain C2.2, C3.3, C4.4, and C6.6 Powered Generating Sets{1901, 7451}
C9.3 Engines for Caterpillar Built Machines Unit Injector - Remove
C27 and C32 Engines for Caterpillar Built Machines Electronic Control System Components
C4.4 Industrial Engine Valve Mechanism Cover
C4.4 Industrial Engine Air Inlet and Exhaust System - Inspect
C15 and C18 Engines Compression Brake - Inspect/Adjust/Replace
C13, C15, and C18 Tier 4 Interim Engines Cat ET Service Features
Idler Oil Fill Volume {4159, 4159} Idler Oil Fill Volume {4159, 4159}
C175 Generator Sets Varistor - Inspect
Rework Procedure for the Connection of Speed Adjust Circuit to Control Panels on Certain C4.4Powered Generating Sets{7332, 7451} Rework Procedure for the Connection of Speed Adjust Circuit to Control Panels on Certain C4.4Powered Generating Sets{7332, 7451}
Using the 6V-7840 Deck Checking Tool Assembly {0701, 1201, 7225} Using the 6V-7840 Deck Checking Tool Assembly {0701, 1201, 7225}
C15 and C18 Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
C15 and C18 Engines Valve Actuators - Check
C27 and C32 Tier 4 Engines Sensor Supply - Test
3516C Generator Sets Coolant (DEAC) - Change
3516C Generator Sets Coolant (ELC) - Change
3500 Generator Sets Coolant Extender (ELC) - Add
C9.3 Engines for Caterpillar Built Machines Unit Injector - Install
C175-16 Petroleum Generator Set Engines Coolant Level - Check
3516C Generator Sets Coolant Sample (Level 1) - Obtain
G3516 Power Module Coolant Sample (Level 2) - Obtain
3516C Generator Sets Coolant Temperature Regulator - Replace
C15 and C18 Engines Air Compressor - Check - If equipped
320 VH and VM Variable Gauge Undercarriage Track - Separate