Power Sources
简介
发动机向 ECM 供电。 ECM 会向以下部件供电:
- 发动机上的所有传感器
- 喷油泵吸油控制阀
- 废气旁通阀电磁阀
- 诊断接头
- 电子单体喷油器
预热塞由蓄电池直接供电。
ECM 电源
Show/hide table
图 1 | g02423278 |
典型示例 |
ECM 和系统的供电来自 24 伏或 12 伏蓄电池。 ECM 的电源含有以下部件:
- 蓄电池
- 断路开关
- 点火开关
- 保险丝
- 接地螺栓
- ECM 接头
- 机器接口接头
ECM 示意图显示了典型电源电路的主要部件。 蓄电池电压通常连接至 ECM。 来自点火开关的输入将会接通 ECM。
可以旁通导线线束来进行故障诊断与排除。
可以使用电子维修工具上的显示屏幕来检查电源电压。
压力传感器电源
Show/hide table
图 2 | g02139716 |
压力传感器示意图 |
ECM 通过 ECM 接头向各传感器提供 5 伏 VDC 电源。 电源具备短路保护功能。 传感器或导线线束中的短路不会损坏 ECM。
电热塞的电源
Show/hide table
图 3 | g02149319 |
典型示例 |
Caterpillar Information System:
C4.4 Industrial Engine Fuel Injection
C4.4 Industrial Engine Introduction
C4.4 Industrial Engine Lubrication System
Bench Test Procedure for Hydraulic Piston Pumps {0784, 5070} Bench Test Procedure for Hydraulic Piston Pumps {0784, 5070}
C4.4 Industrial Engine Basic Engine
C4.4 Industrial Engine Cooling System
C4.4 Industrial Engine Air Inlet and Exhaust System - Series Turbochargers
Replacement Procedure for Power Conductor Braids With New Silicone Cables{1408, 4460} Replacement Procedure for Power Conductor Braids With New Silicone Cables{1408, 4460}
C27 Industrial Engine and C27 Locomotive Engine Engine Speed/Timing Sensor - Clean/Inspect
C9.3 Engines for Caterpillar Built Machines Housing (Front) - Install
C9.3 Engines for Caterpillar Built Machines Housing (Front) - Remove
2010/04/26 Fuel Injection Nozzles for 3056E Engines {1251, 1290}
C4.4 Industrial Engine Electronic Control System
CB22B, CB24B, CB32B and CC24B Utility Compactors Fuel System - Prime
C9.3 Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
349F and 352F Excavators Hydraulic System Pump Control (Negative Flow) - Test
C27 and C32 Engines for Caterpillar Built Machines Exhaust Cooler (NRS) - Clean
2010/05/31 A New Spark Plug Is Used in G3600 Engines {1550, 1555}
C9.3 Engines for Caterpillar Built Machines Front Cover - Remove and Install
2010/05/06 Changes in Performance After Replacing High Hour Fuel Injectors on Certain 3412E Marine Engines {1251, 1254, 1290, 1713}
C4.4 Industrial Engine Crankshaft Pulley - Check
C6.6 Industrial Engine Fuel Priming Pump - Remove and Install - Electric Fuel Lift Pump (EFLP)
C6.6 Industrial Engine Fuel Filter Base - Remove and Install - Single Secondary Fuel Filter
C6.6 Industrial Engine Fuel Manifold (Rail) - Remove and Install