C9.3 Engines for Caterpillar Built Machines Caterpillar


Housing (Front) - Install

Usage:

336E L BMH

安装步骤

表 1
所需工具    
工具     零件号     零件描述     数量    
A.     8T-9011     部件清洁剂     1    
B     4C-9500     快速固化底漆     1    
C     −     Loctite 17430     1    

\




    图 1g01360166



    图 2g01351898

  1. 使用工具 (A) ,清洁前壳体 (6) 接合面。

  1. 在接合面上涂抹工具 (B) 。 至少等待 3 到 5 分钟使底漆风干。

    注: 确保机油供应槽没有被多余的密封胶堵塞。

  1. 将一条宽度为 3.0 ± 0.5 mm (0.12 ± 0.02 in) 的工具 (C) 涂抹到接合面上。 请参阅图 2。 均匀地铺开密封胶。 必须在涂抹密封胶后的 10分钟内安装前壳体 (6) 。

  1. 将前壳体 (6) 放置到缸体上。



    图 3g02149190

  1. 安装螺栓 (3) 。 安装螺栓 (4) 和 (5) 。



    图 4g01360127

  1. 放置发动机安装件 (2) 并安装螺栓 (1) 。

End By:

  1. 安装凸轮轴。
  2. 安装曲轴前油封。
  3. 安装减振器和皮带轮。

Caterpillar Information System:

C9.3 Engines for Caterpillar Built Machines Housing (Front) - Remove
2010/04/26 Fuel Injection Nozzles for 3056E Engines {1251, 1290}
3412E, C30 and C32 Marine Engines Heat Exchanger - Assemble - With Fuel Cooler
3412E, C30 and C32 Marine Engines Heat Exchanger - Disassemble - With Fuel Cooler
3512C Petroleum Engines Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
C6.6 Industrial Engine Turbocharger
3512C Petroleum Engines Fuel Injector - Inspect/Adjust/Replace
SPF343 and SPF343C Trailer Mounted Pumpers Engine Valve Lash - Check
C27 and C32 Generator Sets Engine Mounts - Inspect
3512B HD SR500 Generator Sets Engine Air Precleaner - Check/Clean
C175-16 PETROLEUM ENGINES Water Temperature Control Valve - Remove - Separate Circuit Aftercooler (SCAC)
C18 Marine Engines Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
C27 Industrial Engine and C27 Locomotive Engine Engine Speed/Timing Sensor - Clean/Inspect
Replacement Procedure for Power Conductor Braids With New Silicone Cables{1408, 4460} Replacement Procedure for Power Conductor Braids With New Silicone Cables{1408, 4460}
C4.4 Industrial Engine Air Inlet and Exhaust System - Series Turbochargers
C4.4 Industrial Engine Cooling System
C4.4 Industrial Engine Basic Engine
Bench Test Procedure for Hydraulic Piston Pumps {0784, 5070} Bench Test Procedure for Hydraulic Piston Pumps {0784, 5070}
C4.4 Industrial Engine Lubrication System
C4.4 Industrial Engine Introduction
C4.4 Industrial Engine Fuel Injection
C4.4 Industrial Engine Power Sources
C4.4 Industrial Engine Electronic Control System
CB22B, CB24B, CB32B and CC24B Utility Compactors Fuel System - Prime
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.