Front Cover - Remove and Install
拆卸步骤
开始:
- 拆下减振器和皮带轮。
- 拆下螺栓 (1) 和皮带张紧器 (2) 。 拆下螺栓 (3) 和螺栓 (4) 。 拆下双头螺栓 (5) ，然后拆下前盖 (6) 和密封垫。
Show/hide table
 | |
| 图 1 | g02149467 |
安装步骤
- 按照相反顺序安装前盖 (6) 。
Caterpillar Information System:
2010/05/31 A New Spark Plug Is Used in G3600 Engines {1550, 1555}
C27 and C32 Engines for Caterpillar Built Machines Exhaust Cooler (NRS) - Clean
349F and 352F Excavators Hydraulic System Pump Control (Negative Flow) - Test
C9.3 Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
CB22B, CB24B, CB32B and CC24B Utility Compactors Fuel System - Prime
C4.4 Industrial Engine Electronic Control System
C4.4 Industrial Engine Power Sources
C4.4 Industrial Engine Fuel Injection
C4.4 Industrial Engine Introduction
C4.4 Industrial Engine Lubrication System
Bench Test Procedure for Hydraulic Piston Pumps {0784, 5070} Bench Test Procedure for Hydraulic Piston Pumps {0784, 5070}
C4.4 Industrial Engine Basic Engine
2010/05/06 Changes in Performance After Replacing High Hour Fuel Injectors on Certain 3412E Marine Engines {1251, 1254, 1290, 1713}
C4.4 Industrial Engine Crankshaft Pulley - Check
C6.6 Industrial Engine Fuel Priming Pump - Remove and Install - Electric Fuel Lift Pump (EFLP)
C6.6 Industrial Engine Fuel Filter Base - Remove and Install - Single Secondary Fuel Filter
C6.6 Industrial Engine Fuel Manifold (Rail) - Remove and Install
C6.6 Industrial Engine Fuel Injection Lines - Remove
G3520E Generator Set Engines Air Lines
C6.6 Industrial Engine Fuel Injection Lines - Install
C6.6 Industrial Engine Inlet Air Control - Remove - NRS Inlet Air Mixer
C6.6 Industrial Engine Inlet Air Control - Install - NRS Inlet Air Mixer
C6.6 Industrial Engine Fuel Injection Pump - Remove
Procedure to Install a New Software with Droop Capability for Load Sharing on Certain C11 and C15 Industrial Engines{1901, 1920} Procedure to Install a New Software with Droop Capability for Load Sharing on Certain C11 and C15 Industrial Engines{1901, 1920}