E255 Diagnostic Reset
Conditions Which Generate This Code:
This code becomes active for three seconds after another event code has been cleared.
System Response:
The warning lamp will be illuminated and the diagnostic lamp will flash the event code.
E255-1
None
Test Step 1.
This event indicates that another event code has been cleared. This event does not represent a fault in the Electronic Control Module (ECM).
No troubleshooting is required.
Results:
- OK - STOP
Caterpillar Information System:
330F MHPU Mobile Hydraulic Power Unit Machine System Oil Filter (Return) - Case Drain Filter
2010/03/08 New Rocker Arm Assemblies Are Available on Some Machines {1123}
Installation Procedure for the New Floating Aftercooler Core for Certain C30 and C32 Marine Engines{1063, 1380, 3319} Installation Procedure for the New Floating Aftercooler Core for Certain C30 and C32 Marine Engines{1063, 1380, 3319}
2010/02/05 New Software Is Used for C175-16 Generator Set Engines {1901, 1920}
C27 and C32 Tier 4 Engines Alternator and Regulator
C7 Marine Engine Closed Crankcase Ventilation (CCV) Filter Service Indicator - Check
G3500B Engines Fuel Lines
Procedure for Installing the Air Seals that Are Included in the 337-7215 Seal Kit on Certain G3500 Engines{1063, 1380, 7555} Procedure for Installing the Air Seals that Are Included in the 337-7215 Seal Kit on Certain G3500 Engines{1063, 1380, 7555}
Turbine Wheel for Torque Converters Used with Power Shift Transmissions {3101, 3131} Turbine Wheel for Torque Converters Used with Power Shift Transmissions {3101, 3131}
C27 Industrial Engine and C27 Locomotive Engine Configuration Parameters
C27 Industrial Engine and C27 Locomotive Engine Product Description
C13, C15, and C18 Tier 4 Interim Engines Engine Shutdown While Idling
C7.1 Industrial Engine and Generator Set Digital Throttle Position Sensor Circuit - Test
795F AC and 795F AC XQ Off-Highway Trucks Indicator Lamp (Inverter Active) - Check
G3500 Generator Sets Coolant (NGEC) - Change
G3500H 60Hz Generator Sets Coolant Level - Check
G3500 Generator Sets Coolant Sample (Level 1) - Obtain
C175-16 PETROLEUM ENGINES Crankshaft - Remove
G3406 Engine Coolant Sample (Level 2) - Obtain
G3406 Engine Cylinder Pressure - Test/Record
G3304B and G3306B Engines Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
C18 Generator Set Engine Mounts - Inspect
G3500 Engines Engine Valve Lash and Bridge - Check
C175-16 PETROLEUM ENGINES Crankshaft - Install