Indicator Lamp (Inverter Active) - Check
变频器柜配有两个变频器启动指示灯,位于减速接触器腔室上方。 当直流电源母线上的电压大于 150.0 VDC 时,这两个指示灯点亮。 这两个指示灯的工作与钥匙起动开关的状态无关。
变频器启动指示灯作为直观辅助装置,用来指示直流电源母线的状态。 变频器启动指示灯并不设计用作直流电源母线已完成放电的绝对指示。 无论变频器启动指示灯的状态如何,在任意高电压系统部件上执行任何维修前,均必须手动测量确认直流电源母线电压低于 50.0 VDC。
通过执行以下程序来确认变频器启动指示灯的工作:
- 准备维修的机器。 请参阅操作和保养手册, "使机器作好保养准备"。
- 起动发动机。
- 踩下行车制动器踏板并且将换挡操纵杆移到 D 位置。
- 将换挡操纵杆移到 P 位置。
Show/hide table
图 1 g01942453 - 退出驾驶室并确认变频器启动指示灯 (1) 和 (2) 的工作。
- 如果两灯均不点亮,请联系您的 Caterpillar 代理商。
Caterpillar Information System:
C7.1 Industrial Engine and Generator Set Digital Throttle Position Sensor Circuit - Test
C6.6 Marine Generator Set E255 Diagnostic Reset
330F MHPU Mobile Hydraulic Power Unit Machine System Oil Filter (Return) - Case Drain Filter
2010/03/08 New Rocker Arm Assemblies Are Available on Some Machines {1123}
Installation Procedure for the New Floating Aftercooler Core for Certain C30 and C32 Marine Engines{1063, 1380, 3319} Installation Procedure for the New Floating Aftercooler Core for Certain C30 and C32 Marine Engines{1063, 1380, 3319}
2010/02/05 New Software Is Used for C175-16 Generator Set Engines {1901, 1920}
C27 and C32 Tier 4 Engines Alternator and Regulator
C7 Marine Engine Closed Crankcase Ventilation (CCV) Filter Service Indicator - Check
G3500B Engines Fuel Lines
Procedure for Installing the Air Seals that Are Included in the 337-7215 Seal Kit on Certain G3500 Engines{1063, 1380, 7555} Procedure for Installing the Air Seals that Are Included in the 337-7215 Seal Kit on Certain G3500 Engines{1063, 1380, 7555}
Turbine Wheel for Torque Converters Used with Power Shift Transmissions {3101, 3131} Turbine Wheel for Torque Converters Used with Power Shift Transmissions {3101, 3131}
C27 Industrial Engine and C27 Locomotive Engine Configuration Parameters
G3500 Generator Sets Coolant (NGEC) - Change
G3500H 60Hz Generator Sets Coolant Level - Check
G3500 Generator Sets Coolant Sample (Level 1) - Obtain
C175-16 PETROLEUM ENGINES Crankshaft - Remove
G3406 Engine Coolant Sample (Level 2) - Obtain
G3406 Engine Cylinder Pressure - Test/Record
G3304B and G3306B Engines Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
C18 Generator Set Engine Mounts - Inspect
G3500 Engines Engine Valve Lash and Bridge - Check
C175-16 PETROLEUM ENGINES Crankshaft - Install
G3304B and G3306B Engines Inlet Air System - Check
PMG3516 Power Module Rotating Rectifier - Inspect/Test