Elbow Fitting Available To Allow "Quick-Drain" Line To Oil Pan{1302,1307}
Usage:
3208 ( 75V, 1Z ) Marine Engines
The drain plugs in the oil pan on 3208 Marine Engines have 3/4"-16 threads. The 307948 Elbow Fitting is available to install in place of a drain plug. A 3K0360 Seal is required when installing the elbow in the oil pan. The other end of the 307948 Elbow Fitting has a 37° flare and 3/4"-16 threads. This end of the fitting can be connected to a "quick-drain" line and suction pump.
Caterpillar Information System:
1989/03/06 New Bleed Screw Used On 7000 Series Fuel Injection Nozzles{1254}
1989/03/06 New Engine Wall Charts Give Maintenance Management Recommendations{0374,0375,7500,7557,7580}
1989/03/06 High Horsepower Standby Generator Set Engines{1000}
1989/02/27 Troubleshooting 3406B (PEEC) Truck Engines Equipped With Power Demand Cruise Control (PDCC){1705}
1989/02/27 Updated 7X1830 SPM For 8T5282 3406B PEEC DDT Available{1707,1705}
1989/02/27 New Features And Enhanced Fault Codes Available In New PEEC Personality Modules{1707,1705}
1989/02/27 Surface Marks On Roller Bearing Cages Are Not Cracks{7551}
1989/02/20 New Gasket Replaces O-Ring Seal On Manual Valve Group And Plug Group Used For Testing Cylinder Pressure{1101}
1989/02/20 Part Numbers For Relays And Clip In Electronic Modular Control Panel{4450,4469,7451}
1989/02/13 Improved Valve Lifter Assemblies; Better Insert Retention{1112}
1989/02/13 New Nut In Fresh And Raw Water Pumps Has More Corrosion Resistance{1371}
1989/02/13 Cold Start Procedures For 3406 (PEEC) Truck Engines{1705}
1989/03/20 Improved Magnet Used In Rack Assembly{1705,1286}
1989/03/20 Correct Torque For Bolts That Fasten Pulley To Stub Shaft In Radiator Group{1350}
1989/03/27 Limitations On Engine Cranking Time{1453,1401}
1989/03/27 Understanding "Shorts," "Opens" and "Intermittents"{1400}
1989/03/27 Understanding Causes Of Blown Fuses And Tripped Circuit Breakers{1400,1420}
1989/03/27 How To Troubleshoot A Short-To-Ground In Power Wiring{1400}
1989/03/27 Preventive Maintenance For Batteries{1401}
1989/03/27 Bolts Must Be Reinstalled In Same Holes In Companion Flange And Gear Output Flange{3305,3360}
1989/03/27 Exciter Rotor Retaining Bolt Torque Specification{4457}
1989/03/27 Additional Remanufactured Parts Available{1000}
1989/04/03 Follow Recommended Procedure When Adding Oil To Track Rollers And Idlers{4154,4159,4180}
1989/04/03 New Cylinder Blocks, Main Bearing Caps, And Main Bearing Cap Bolts Used{1201}