Piston Cooling Jets - Remove and Install
Start By:
- Remove the engine oil pump, if necessary.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove the cylinder block cover from the side of the engine.
Show/hide table
Illustration 1 g00913178 Show/hide tableIllustration 2 g00913185 - Remove bolts (1) and retainer (2).
- Remove piston cooling jet (3) from the inside of the engine.
- Install piston cooling jet (3) in the reverse order of removal.
- Ensure that the oil holes in the end of the piston cooling jet are facing toward the piston.
Caterpillar Information System:
Replacement of High Pressure Fuel Lines on C7 On-highway Engines{1252, 1254} Replacement of High Pressure Fuel Lines on C7 On-highway Engines{1252, 1254}
C9.3 Engines for Caterpillar Built Machines Fuel Temperature Is High
797F and 797F XQ Off-Highway Trucks Machine Systems Power Converter (CAB) - Remove and Install
349F and 352F Excavators Cab Door
C9.3 Tier 4 Interim Engines Power Is Intermittently Low or Power Cutout Is Intermittent
C9.3 Tier 4 Interim Engines Fuel Pressure Is High
2010/01/25 Installing Orifice Plates in some G3520C Landfill Engines {1063, 1380}
349F and 352F Excavators Power Receptacle - If Equipped
2009/12/09 A New Undersized Connecting Rod Bearing Is Available for All C27 and C32 Engines {1225}
C13, C15, and C18 Tier 4 Final Engines Pressure Sensor (DPF Inlet)
349F and 352F Excavators Operation Information
349F and 352F Excavators Equipment Lowering with Engine Stopped
349F and 352F Excavators Joystick Controls Alternate Patterns
3508, 3512 and 3516 Generator Set Engines Pistons and Connecting Rods - Remove
3508, 3512 and 3516 Generator Set Engines Pistons and Connecting Rods - Install
3508, 3512 and 3516 Generator Set Engines Cylinder Liner - Remove
3508, 3512 and 3516 Generator Set Engines Cylinder Liner - Install
2009/12/09 Fuel Injection Pump Gear on 3054C, C3.3, C6.6, C4.4 and C4.4 (Mech) Engines {1251, 1290}
2010/01/08 Fuel Injection Pump Gear on 3054C, C3.3, C6.6, C4.4 and C4.4 (Mech) Engines {1251}
793F Off-Highway Truck Machine Systems Magnetic Switch (Main Power) - Remove and Install
Installation of the Synchronization Module{4480} Installation of the Synchronization Module{4480}
793F Off-Highway Truck Machine Systems Display Module - Remove and Install
Track Servicing Equipment, Tooling, Literature, and Training Review {0374, 4169, 4170, 4171, 4172, 4174, 4175, 4176} Track Servicing Equipment, Tooling, Literature, and Training Review {0374, 4169, 4170, 4171, 4172, 4174, 4175, 4176}
793F Off-Highway Truck Machine Systems Electronic Control Module (Advisor) - Remove and Install - VIMS