2P8316 Dowel Now Available For Parts Service{0652}
Usage:
The 2P8316 Dowels used in the 2P8315 Bracket Assembly are now available for parts service. The 2P8315 Bracket Assembly is part of the 3P1551 Adapter Group and is used as a support for sleeve metering fuel systems when they are installed on the fuel injection test bench.
The 2P8316 Dowel is adaptable to all 2P8315 Bracket Assemblies. The dowels must be installed in the bracket assembly as shown in the illustration for the injection pump to be in correct alignment with the test bench.
Caterpillar Information System:
1979/04/30 New " Drive 6V94 Universal Joint Is Available{0612,1253}
1979/04/23 Dowtherm Test Strips No Longer Available{0651,1350}
1979/04/23 Inspection Of Oil Pump After Long Periods Of Service Can Prevent Engine Damage{1304}
1979/04/23 New Oil Cooler Bonnets Used On 3408 And 3412 Engines{1378,1354,1380}
1979/04/23 Careful, Correct Installation And Maintenance Of Fuel Injection Lines Is Very Important To Prevent Possible Engine Damage, Fire And Other Problems{1252}
1979/04/16 90° Elbows On Quick Disconnect Couplers Make Installation Easier{0690}
1979/04/16 How To Extend The Service Life Of 1P5550 Fuel Cam Locking Tool Assembly{0654,1250}
1979/04/16 Testing And Adjusting Procedure For 5P4210 Modular Cab Tilting Cylinder And Valve{0620}
1979/04/09 During Installation Of Crankshaft Piston Ring Seals, Put Silicone Grease In The Groove And On The Seal{1160,1161}
1979/04/09 New Exhaust Valve Has Improved Three-Piece Construction{1105}
1979/04/09 Serial Numbers Used Instead Of Test Numbers On Power Shift Transmissions{3150,7557}
1979/04/09 Conversion Group Available To Install Woodward Governor On Engines Equipped With Mechanical Governor{1264}
1979/04/30 The Service Life Of A Power Shift Transmission Is In Direct Relation To The Maintenance Of Its Lubrication System{3004,3179,3150}
1979/04/30 New Ring Gears Used In Flywheel Assemblies{1158}
1979/04/30 Seals (Double-Lip Type) Made Of Viton Material Are Now Used In Vickers Pumps Which Have Steel-Backed Bronze Plates Between Rotor And End Plates{5055}
1979/04/30 Improved Gasket Now Used Between The Flywheel Housing And The Cylinder Block{1157,1201}
1979/04/30 Liner Seat Insert Now Available{1217}
1979/04/30 New Design Exhaust Gasket Used In Air Lines Group{1061}
1979/05/07 New 6V116 Water Sleeve Removal Tool Is Available{0621,1101}
1979/05/07 New Hose Assembly Will Give Longer Service Life With High Oil Temperatures{3314}
1979/05/07 Part Numbers Of Bearings To Use For Service Replacement In Fuel Injection Pump Housings For Sleeve Metering Fuel Systems; Correction To Special Instruction For Installation.{1253}
1979/05/07 Change In Part Number Of Water Temperature Regulator Used In Attachment Oil Cooler Groups{1355,1378}
1979/05/07 An Ammeter Calibration Group Is Now Available{0651}
1979/05/07 New Oil Pump Has Improved Relief Valve For Better Pressure Control{1304}