Clean Emissions Module Wiring - Remove and Install
- Disconnect harness assemblies (1) and (3).
- Loosen allen bolt and disconnect harness assembly (2).
Show/hide table
Illustration 2 g02195382 - Disconnect harness assemblies (4) and (5).
- Remove bolt (6) and position the cable assembly out of the way.
Show/hide table
Illustration 3 g02195737 - Disconnect harness assembly (7) and remove the exhaust module wiring.
Show/hide table
Illustration 1 | g02194933 |
Note: Put orientation and location marks on all cable strap locations and on all insulation wraps for installation purposes.
- Install the exhaust module wiring harness in the reverse order.
- Tighten allen bolt that secures harness assembly (2) to a torque of
3.3 ± 0.7 N·m (30 ± 6 lb in) .
- Tighten allen bolt that secures harness assembly (2) to a torque of
Caterpillar Information System:
C13 Engines for Caterpillar Built Machines Pressure Sensor (DPF) - Remove and Install - Differential Pressure, Clean Emissions Module
C18 Marine Generator Set Product Description
C18 Marine Auxiliary Engine Product Description
C15 and C18 Industrial Engines Nozzle Heater Harness - Remove and Install
C13 Engines for Caterpillar Built Machines Fuel Manifold (ARD) - Remove and Install - Clean Emissions Module
G3304B and G3306B Engines Diagnostic Trouble Codes
G3304B and G3306B Engines Fuel Shutoff - Test
793F and 797F Off-Highway Trucks Braking System Brakes Overheat
C13 Engines for Caterpillar Built Machines Air Control Valve - Remove and Install - ARD Combustion, Clean Emissions Module
793F and 797F Off-Highway Trucks Braking System MID 116 - CID 2448 - FMI 14
793F and 797F Off-Highway Trucks Braking System MID 116 - CID 2448 - FMI 09
793F and 797F Off-Highway Trucks Braking System MID 116 - CID 2448 - FMI 02
C7.1 Industrial Engine and Generator Set Engine Pressure Sensor Open or Short Circuit - Test
C7.1 Industrial Engine and Generator Set Ignition Keyswitch Circuit and Battery Supply Circuit - Test
C32 Marine Engine Pinion Clearance - Adjust
C18 Marine Engines Engine Speed/Timing Sensor - Clean/Inspect
C13 Engines for Caterpillar Built Machines Flame Detection Temperature Sensor - Remove and Install - Clean Emissions Module
C13, C15, and C18 Tier 4 Final Engines Boost Pressure Sensor
C27 and C32 Engines for Caterpillar Built Machines Atmospheric Pressure Sensor
C13 Engines for Caterpillar Built Machines Soot Antenna - Remove and Install
C13 Engines for Caterpillar Built Machines Diesel Particulate Filter - Remove and Install - Clean Emissions Module
C7.1 Industrial Engine and Generator Set Idle Validation Switch Circuit - Test
C13 Engines for Caterpillar Built Machines Catalyst - Remove and Install - Diesel Oxidation Catalyst, Clean Emissions Module
C7.1 Industrial Engine and Generator Set Indicator Lamp Circuit - Test