Operator Station Action Alarm - Check
Note: This check occurs at a minimum daily and as a change in ambient nose occurs, or as other relevant changes occur.
Follow the below procedure to check the operator station alarm and event feedback:
- Follow the "Machine Preparation" procedure. Refer to Section Before Operation - Machine Preparation of this manual.
- Pull out the remote shutdown switch on the remote operator station.
- Place the operator station disconnect switch in the ON position.
- Power on the touchscreen and touchscreen PC.
- Power on the vision monitor and vision PC (if the machine is equipped with cameras).
- Open the Command for Dozing user interface on the touchscreen by double-clicking the icon.
- Confirm that the action alarm on the station is activated.
Note: Operator Station Alarm check is now complete. Refer to Section Operation - Machine Operation within this manual for additional information to continue to activate RC.
Caterpillar Information System:
D11 Track-Type Tractor Power Train System Screens - Clean
C175-16 Locomotive Engine Fuel Injector - Replace
D8T Track-Type Tractor Differential Steering System
D6 Track-Type Tractor Machine Systems Piston Pump (Steering) - Remove and Install
C175-16 Locomotive Engine Diesel Exhaust Fluid System - Inspect/Clean
C175-16 Locomotive Engine Crankshaft Vibration Damper seals - Replace
C175-16 Locomotive Engine Crankshaft Vibration Damper Bolts - Inspect
C175-16 Locomotive Engine Diesel Exhaust Fluid Pump Check Valves - Replace
C175-16 Locomotive Engine Diesel Exhaust Fluid Pump Diaphragm - Replace
Installation of the 567-0669 Coupler Lines Gp on Certain Wheel Loaders {5057, 5133, 6129} Installation of the 567-0669 Coupler Lines Gp on Certain Wheel Loaders {5057, 5133, 6129}
D6 Track-Type Tractor Machine Systems Hydraulic Tank - Assemble
D6 Track-Type Tractor Winch Wire Rope - Install - If Equipped
D6 XE Track-Type Tractor Power Train Electric Drive Wiring - Remove and Install
D6 Track-Type Tractor Power Train System Oil And Screens - Change/Clean - XE Electric Drive
Rework Procedure for Joystick Mounting Bracket on Certain MD6250 and MD6310 Rotary Drills {1408, 5059, 5063, 5705} Rework Procedure for Joystick Mounting Bracket on Certain MD6250 and MD6310 Rotary Drills {1408, 5059, 5063, 5705}
D6 Track-Type Tractor Machine Systems Winch - Remove and Install
Check the Rear Axle Drain Plug on AD60 Underground Articulated Trucks {3260} Check the Rear Axle Drain Plug on AD60 Underground Articulated Trucks {3260}
903 D Wheel Loader Power Train Tire and Rim - Remove and Install
950 GC Wheel Loader Additional Messages - Japan Only Films
Updated Cylinder Block Rear Housing Gasket is Now Used on Certain Cat® Engines {1166} Updated Cylinder Block Rear Housing Gasket is Now Used on Certain Cat® Engines {1166}
950 GC Wheel Loader Safety Messages - Japan Only Films
D6 XE Track-Type Tractor Power Train Power Inverter - Remove and Install
3512E Oil Well Service Engine Maintenance Interval Schedule
950 GC Wheel Loader Operator Controls