Head Liner May Sag on Certain Compact Wheel Loaders {7329}
- Compact Wheel Loader
- 906K (S/N: L661-UP)
- 906M (S/N: H661-UP)
- 907K (S/N: L771-UP)
- 907M (S/N: H771-UP)
- 908K (S/N: L881-UP)
- 908M (S/N: H881-UP)
- 910K (S/N: L221-UP; AY41-UP)
- 910M (S/N: H221-UP)
- 914K (S/N: CD21-UP; L241-UP)
- 914M (S/N: H241-UP)
- 918M (S/N: H261-UP)
- 906M (S/N: H661-UP)
Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.
Problem
Reports have been received that the head liner equipped with speakers may sag on the machines listed above.
Solution
In the event of failure, follow the procedure below:
Rework Procedure
Show/hide table
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility. |
- Remove the speaker from the head liner.
Show/hide table
Illustration 2 g06309917 (A) 344-5673 Nut - Install the nut (A) on the existing stud.
Show/hide table
Illustration 3 g06309918 (B) 4E-7497 Spacer - Install the spacer (B) on the existing stud.
Show/hide table
Illustration 4 g06309919 Drill location Show/hide tableIllustration 5 g06310192 Drill location - Drill at the marked location for the screw.
Show/hide table
Illustration 6 g06309920 (C) 9X-2038 Washer
(D)3E-6924 Screw - Install the washer (C) and screw (D) through headliner into the spacer (B).
Show/hide table
Illustration 7 g06309922 (E) Speaker - Install the speaker (E).
Show/hide table
Illustration 1 | g06309915 |
Speaker location |
Caterpillar Information System:
CG137-08 Engines Turbocharger - Assemble
CG137-08 Engines Turbocharger - Disassemble
D8T Track-Type Tractor Electronic Control (Fan Hydraulic System)
Improved Discharge Hydraulic Hose Assembly Routing is Now Used on Certain 950L, 950M, 962L, and 962M Medium Wheel Loaders {5057} Improved Discharge Hydraulic Hose Assembly Routing is Now Used on Certain 950L, 950M, 962L, and 962M Medium Wheel Loaders {5057}
330 GC and 330 Excavator Access Door and Cover Locations
D8T Track-Type Tractor Machine Systems Hydraulic Tank - Remove and Install
903D Compact Wheel Loader Access Doors and Covers
C175–16 Locomotive Engine Diesel Exhaust Fluid Quality - Test
C175–16 Locomotive Engine Measuring Exhaust Temperature
986K Wheel Loader Engine Supplement Fan Group (Includes Fan, Fan Shroud, and Hydraulic Fan Motor) - Remove and Install
Improved Return Hydraulic Hose Assembly Routing Now Used on Certain 950L, 950M, 962L, and 962M Medium Wheel Loaders {5057} Improved Return Hydraulic Hose Assembly Routing Now Used on Certain 950L, 950M, 962L, and 962M Medium Wheel Loaders {5057}
Generator Rotor Magnets Separate on Certain D7E Track Type Tractors {4450} Generator Rotor Magnets Separate on Certain D7E Track Type Tractors {4450}
903D Compact Wheel Loader Engine Crankcase Breather - Replace - and PCV Valve Check
903D Compact Wheel Loader Engine Oil Level - Check
PL61 Pipelayer Systems System Pressure - Release
903D Compact Wheel Loader Fuel System Filter and Water Separator - Replace
988K XE Wheel Loader Connector Contact Description
903D Compact Wheel Loader Fuel System Water Separator - Drain
988K XE Wheel Loader Power Supply (Priming) - Test - 988 XE Wheel Loader
903D Compact Wheel Loader Fuel Tank Water and Sediment - Drain
Cat® Command for Dozing, Operator Station Emerging Symptom Information
C9.3B Engines Atmospheric Pressure Sensor
C9.3B Engines Inlet Manifold Air Pressure Sensor
Improved A/C Compressor Is Now Available on Certain Large Wheel Loaders and Large Wheel Dozers {1802} Improved A/C Compressor Is Now Available on Certain Large Wheel Loaders and Large Wheel Dozers {1802}