Transmission Hydraulic Control Valve - Remove and Install
Start By:
- Remove the priority valve.
- Loosen four bolts (1) that hold the transmission control valves to the transmission.
- Lift the bolts enough to clear the transmission. Install a rubber band to hold up the bolts.
- Pull the control valves out of the transmission. Use two persons to remove the control valves. The weight of the control valves is
41 kg (90 lb) .
Show/hide table
Illustration 1 | g00628516 |
- Install the control valves on the transmission and install bolts (1)
- Tighten bolts (1) to a torque of
48 ± 4 N·m (35 ± 3 lb ft) .
- Tighten bolts (1) to a torque of
Caterpillar Information System:
Installing GRADE Firmware on the EC520 Controller through the Web Interface or Winflash {7620} Installing GRADE Firmware on the EC520 Controller through the Web Interface or Winflash {7620}
D3-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Fuel System Primary Filter (Water Separator) - Drain
CX48–P2560–3060 Petroleum Transmission Magnetic Screen (Transmission)
D3-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Fuel System Filter (In-Line) - Replace
D-Series and D2-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Equipment Lowering Control Valve - Check
C175-16 Locomotive Engine Accessory Drive
Front Drive Shaft Bearing Lip Seals May Fail on Certain Wheel Dozers and Large wheel Loaders {3159, 3253} Front Drive Shaft Bearing Lip Seals May Fail on Certain Wheel Dozers and Large wheel Loaders {3159, 3253}
C175-16 Locomotive Engine Flywheel
D3-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Axle Bearings - Lubricate - MTL Only
Magnetic Pick Up (MPU1) Sensor Calibration Procedure for Certain Cat® Products {1912} Magnetic Pick Up (MPU1) Sensor Calibration Procedure for Certain Cat® Products {1912}
D3-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Capacities (Refill)
D3-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Radiator Tilting
CX48–P2560–3060 Petroleum Transmission Transmission Planetary
D8T Track-Type Tractor Engine Supplement Temperature Sensor (DPF Inlet, Flame Detect) - Remove and Install
C175-16 Locomotive Engine Solenoid Valve - Test - Engine
D3-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Fuel System Primary Filter (Water Separator) Element - Replace
C175-16 Locomotive Engine Diagnostic Trouble Codes
D3-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Fuel System Priming Pump - Operate
D3-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Fuses - Replace
C175-16 Locomotive Engine Event Codes
C175-16 Locomotive Engine DEF Pressure Is High
C175-16 Locomotive Engine DEF Pressure Is Low
C175-16 Locomotive Engine Solenoid Valve - Test - Aftertreatment
D8T Track-Type Tractor Power Train Torque Converter - Remove and Install