Electric Starting Motor
Show/hide table
| 图 1 | g01401956 |
Show/hide table
| 图 2 | g01401955 |
A-A 视图 | |
当从小齿轮端观看电起动马达时，马达旋转方向如下。 ... 顺时针
25 °C (77 °F) 时无负载
- 车速 ... 6950 ± 1650 rpm
- 电流 ... 115 ± 25 A
- 电压 ... 23 VDC
- 电流 ... 115 ± 25 A
(B) 小齿轮与壳体之间的间隙 ... 9.1 mm (0.36 in)
(1) 接地接线端螺母的最终安装扭矩 ... 26 ± 1.5 N·m (230 ± 13.00 lb in)
(2) 接地接线端螺母的最终安装扭矩 ... 2.25 ± 0.25 N·m (20 ± 2 lb in)
注: 开关接线端必须用热收缩管绝缘。 不要使用模压接线端。
(3) 开关接线端螺母的最终安装扭矩 ... 2.25 ± 0.25 N·m (20 ± 2 lb in)
(4) 马达接线端螺母的最终安装扭矩 ... 26 ± 1.5 N·m (230 ± 13.00 lb in)
注: 蓄电池接线端螺母 (5) 最多可使用三个电缆接线端或导线接线端。 两个电缆接线端可以等于或高于 0 AWG。
(5) 蓄电池接线端螺母的最终安装扭矩 ... 26 ± 1.5 N·m (230 ± 13.00 lb in)
(6) 马达机架接线端螺母的最终安装扭矩 ... 26 ± 1.5 N·m (230 ± 13.00 lb in)
电磁阀组件
20V 和 25 °C (77 °F) 下的耗电量
- 吸合绕组 ... 49.3 ± 3.3 A
- 保持绕组 ... 6.8 A 最大值
Caterpillar Information System:
G3500 Generator Sets Engine Oil Filter - Change
3508B Engine for Caterpillar Built Machines Crankcase Breather
C15 Petroleum Generator Set Engines Turbocharger
3500B Engines and 776D, 777D, 784C, 785C, 789C, 793C and 793D Off-Highway Truck/Tractors Engine Speed/Timing Sensor
2008/03/01 A New Turbocharger is Now Used on Certain On-Highway Engines {1052, 1053}
Electronic Modular Control Panel II+ Paralleling (EMCP II+P) Engine Does Not Shutdown
Electronic Modular Control Panel II+ Paralleling (EMCP II+P) Indicator for Low Oil Pressure
3516C Generator Set Engine Event Codes
3516C Generator Set Engine Diagnostic Trouble Codes
345D, 349D and 349D2 Excavator Machine System Specifications Check Valve (Boom Drift Reduction)
345C Excavator Machine System Specifications Boom Lines
3500 Industrial Engines Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
3500B Engines for Caterpillar Built Power Modules with the ADEM 3 Electronic Control Module Sensor Signal (Analog, Passive) - Test
2007/12/01 A New Internal Wiring Harness for the Injectors is Now Used {1120, 1408}
G3612 and G3616 Engines Prechamber Ignition Body - Install
G3600 Engines Speed Control (Switch) - Test
2008/02/25 A New Plug and O-ring Are Now Used on the Cylinder Head {1100}
2008/02/01 A New Plug and O-ring Are Now Used on the Cylinder Head {1100}
3500 Engines Air Inlet and Exhaust Lines
Electronic Modular Control Panel II+ Paralleling (EMCP II+P) GSC CID 0269 - FMI 03
G3500 Generator Sets Electrical System
C7, C9, C13 and C15 On-highway Engines (California Air Resources Board Idle Reduction Information) Monitoring System - Additional Information for 2008 Caterpillar On-highway Engines which are Regulated by the California Air Resources Board (CARB)
3500B Engines for Caterpillar Built Power Modules with the ADEM 3 Electronic Control Module Sensor Signal (PWM) - Test
G3500 Generator Sets Parallel Operation