Illustration 1 | g01664233 |
Front view of engine |
Note: All the belt running surface of the idler pulleys must be free from paint.
(1) The mounting surfaces of the support bracket must be free from paint.
Illustration 2 | g01624740 |
Tightening sequence |
Use the following procedure to assemble the support bracket:
Note: Use the tightening sequence that is shown in Illustration 2 in order to tighten the bolts (2) and the nuts (7).
- Hand tighten the bolts and the nuts.
- Again, tighten the bolts and the nuts to standard torque.
(3) Use the following procedure to tighten the screws:
- Hand tighten the screws.
- Again, tighten the screws to standard torque.
(4) Use the following procedure to tighten the bolt:
Note: Assemble the bushing so that the bushing is flush with the surface (8).
(C) Approximate position for the bushing ...
- Hand tighten the bolt.
- Again, tighten the bolt to standard torque.
(5) Before assembly, lubricate the outside surface of the bushing with 4C-5599 Anti-Seize Compound.
(6) Final installation torque for three idler pulleys ...