| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 284-5122 | Stand | 1 |
| 8S-7641 | Tube | 1 | |
| 8S-7615 | Pin | 1 | |
| 8S-8048 | Saddle | 1 | |
Start By:
- Remove Bucket.
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
 |
|
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
- Position tooling (A) under loader frame as shown.
Show/hide table
Illustration 2 g06111297 - Disconnect hose assemblies (1).
Show/hide table
Illustration 3 g06111311 - Remove clamp (2) and tube assembly (3).
Show/hide table
Illustration 4 g06111326 - Attach a suitable lifting device to lift cylinder (5) as shown. The approximate weight of lift cylinder (5) is
250 kg (550 lb) . - Remove pins (4) and (6). Remove lift cylinder (5).
- Repeat Step 2 through Step 5 for opposite side.
| |
| Illustration 1 | g06111270 |
- Install Cylinder (5) in reverse order of removal.