Make sure that all of the messages are legible. Clean the messages or replace the messages if you cannot read the words. When you clean the messages, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the messages. Loose adhesive will allow the messages to fall.
Replace any message that is damaged, or missing. If a message is attached to a part that is replaced, install a message on the replacement part. Any Caterpillar dealer can provide new messages.
Illustration 1 | g01398274 |
C32 is shown. |
Illustration 2 | g01398277 |
C32 is shown. |
Lifting Point(1)
This message is located on both sides of the enclosure.
Illustration 3 | g01398322 |
This is the location of a lifting point.
Oil Drain(2)
This message is located on the side of the enclosure.
Illustration 4 | g01398367 |
This is the location of an oil drain.
Coolant Drain(3)
This message is located on the rear of the enclosure, and on the side of the enclosure.
Illustration 5 | g01398331 |
This is the location of a coolant drain.