Fuel Pressure Sensor - Remove and Install - Main
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Before opening the fuel system, the engine must be turned off for at least one minute. |
- Turn the fuel supply to the OFF position.
- Disconnect harness assembly (2) and remove fuel pressure sensor (1) .
Show/hide table
Illustration 1 | g01398033 |
Installation Procedure
- Install fuel pressure sensor (1). Tighten fuel pressure sensor (1) to a torque of 20 ± 3 N·m (15 ± 2 lb ft).
Show/hide table
Illustration 2 | g01398033 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary. |
- Connect harness assembly (2) .
Caterpillar Information System:
C3.3 Industrial Engine Valve Depth - Inspect
C3.3 Industrial Engine Engine Valve Lash - Inspect/Adjust
C3.3 Industrial Engine Compression - Test
14L Motor Grader Machine Systems Centershift Cylinder - Remove and Install
C3.3 Industrial Engine Engine Rating Definitions
C32 Marine Engine Sensors and Electrical Components
C3.3 Industrial Engine Engine Crankcase Pressure (Blowby) - Test
C3.3 Industrial Engine Exhaust Temperature - Test
C3.3 Industrial Engine Wastegate - Test
C2.6 and C3.3B Tier 2 and EU Stage 2 Engines for Caterpillar Built Machines Air Inlet and Exhaust System - Inspect
C3.3 Industrial Engine Fuel System Pressure - Test
C3.3 Industrial Engine Fuel System - Prime
C32 Marine Auxiliary Engines CAN Data Link - Test
CX31 On-Highway Transmission Safety Messages
C32 Marine Auxiliary Engines Cat Data Link - Test
2007/07/30 The Proper Procedure to Enter Claims in SIMSi for Plugged /Restricted Fuel Filters and Water Separators on All Machines {1260, 1261, 1262, 1263}
C32 Power Module Additional Messages
14L Motor Grader Machine Systems Sideshift Cylinder - Remove and Install
G3520B Industrial Engines Start/Stop Control
C3.3 Industrial Engine Before Starting Engine
C3.3 Industrial Engine Fuel Shutoff
2007/08/27 Improvement to the Fuel Injection Pump {1251}
C32 Marine Auxiliary Engine Safety Messages
C32 Power Module Reference Material