Engine Speed/Timing Sensor - Clean/Inspect
Show/hide table
Illustration 1 | g01398834 |
- Remove the sensor from the cover. Check the condition of the end of the magnet. Check for signs of wear and contaminants.
- Clean the metal shavings and other debris from the face of the magnet.
- Install the sensor and adjust the sensor according to the engine's Specifications.
Caterpillar Information System:
C32 Marine Auxiliary Engines Diagnostic Code Cross Reference
14L Motor Grader Machine Systems Blade Tip Cylinder - Remove and Install
2007/10/08 An Improved Aftercooler Core Assembly is Used {1063}
C32 Power Module Reference Material
C32 Marine Auxiliary Engine Safety Messages
2007/08/27 Improvement to the Fuel Injection Pump {1251}
C3.3 Industrial Engine Fuel Shutoff
C3.3 Industrial Engine Before Starting Engine
G3520B Industrial Engines Start/Stop Control
14L Motor Grader Machine Systems Sideshift Cylinder - Remove and Install
C32 Power Module Additional Messages
2007/07/30 The Proper Procedure to Enter Claims in SIMSi for Plugged /Restricted Fuel Filters and Water Separators on All Machines {1260, 1261, 1262, 1263}
C3.3 Industrial Engine Hoses and Clamps - Inspect/Replace
C32 Marine Auxiliary Engines Speed Control (Switch) - Test
C32 Marine Auxiliary Engines Electrical Power Supply - Test
G3408C and G3412C Engines Fan Drive
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 3463 - FMI 2
2007/10/01 New Gas Engines Meet New Emissions Ratings {1278, 191N}
Reuse and Salvage for 3114, 3116, and 3126 Engine Series Cylinder Blocks {1201} Reuse and Salvage for 3114, 3116, and 3126 Engine Series Cylinder Blocks {1201}
345D, 349D and 349D2 Excavators Fuel System - Prime
2007/08/13 New Engine Vision Software Is Now Available {7490, 7620}
C27 and C32 Generator Set Engines Vibration Damper and Pulley
C3.3 Industrial Engine Alternator - Test
C3.3 Industrial Engine Electric Starting System - Test