MID 134 - CID 3323 - FMI 12
Conditions Which Generate This Code:
The diagnostic code becomes active when the left medium range object detection sensor has detected an internal failure.
System Response:
The object detection system is disabled. The status indicator for the system will illuminate red.
Test Step 1. CYCLE THE POWER TO THE SYSTEM
- Place the key start switch and the disconnect switch in the OFF position.
- Turn the disconnect switch and the key start switch to the ON position.
- Check the status of the diagnostic code MID 134 - CID 3323 - FMI 12.
Expected Result:
The diagnostic code is not active.
Results:
- YES - The diagnostic code is not active.
Repair: The diagnostic code was caused by the internal CAN data link of the display. Cycling the power to the system has reset the display. Return the machine to normal operation.
STOP
- NO - The diagnostic code is still active.
Repair: The diagnostic code was caused by an internal failure within the left medium range object detection sensor. Replace the left medium range object detection sensor.
STOP
Caterpillar Information System:
C175-16 and C175-20 Locomotive Engines Engine Oil Filter Housing - Remove
Axle Pinion Seal Leaks on Certain Wheel Loaders {3260, 3278} Axle Pinion Seal Leaks on Certain Wheel Loaders {3260, 3278}
New Front Axle and Rear Axle Groups Are Now Used on Certain Compact Wheel Loaders and Integrated Toolcarriers {3278} New Front Axle and Rear Axle Groups Are Now Used on Certain Compact Wheel Loaders and Integrated Toolcarriers {3278}
A New First and Third Shaft in the Transmission is Now Available on all C Series Wheel Skidders and 938H Wheel Loaders {0374, 0700, 3030, 3063, 3155, 3169, 3170} A New First and Third Shaft in the Transmission is Now Available on all C Series Wheel Skidders and 938H Wheel Loaders {0374, 0700, 3030, 3063, 3155, 3169, 3170}
Transmission Assembly Instructions for the First and Third Shaft in the Transmission on Certain C Series Wheel Skidders and 938H Wheel Loaders {0374, 0700, 3030, 3063, 3155, 3169, 3170} Transmission Assembly Instructions for the First and Third Shaft in the Transmission on Certain C Series Wheel Skidders and 938H Wheel Loaders {0374, 0700, 3030, 3063, 3155, 3169, 3170}
C2.4 Tier 4 Final Engines for Caterpillar Built Machines Component Location
C175-16 and C175-20 Locomotive Engines Pistons, Liners, and Connecting Rods - Remove
Cat® Object Detection System MID 134 - CID 3323 - FMI 11
D5R and D6N Track-Type Tractor Machine Systems Ripper Lift Cylinder - Remove and Install
C13 Engines for Caterpillar Built Machines Retarder - Test
Cat® Object Detection System MID 134 - CID 3323 - FMI 09
Cat® Object Detection System MID 134 - CID 3322 - FMI 12
New Implement Software Is Now Used on Certain 988K Large Wheel Loaders {7610, 7620} New Implement Software Is Now Used on Certain 988K Large Wheel Loaders {7610, 7620}
Cat® Product Link Firmware is Now Available for Certain K Series Wheel Loaders {7606} Cat® Product Link Firmware is Now Available for Certain K Series Wheel Loaders {7606}
C13 Engines for Caterpillar Built Machines Fuel Pressure Is High
340F Excavator Stopping the Engine
988K XE Wheel Loader Fuses and Circuit Breakers - Replace/Reset
Cat® Object Detection System MID 134 - CID 3329 - FMI 03
Cat® Object Detection System MID 134 - CID 3329 - FMI 04
TRS10, TRS14, TRS18, and TRS23 Tilt-Rotator Approved Machines
TRS10, TRS14, TRS18, and TRS23 Tilt-Rotator Lifting and Tying Down
Cat® Object Detection System MID 134 - CID 3330 - FMI 03
Cat® Object Detection System MID 134 - CID 3330 - FMI 04
Cat® Object Detection System MID 134 - CID 3331 - FMI 03