Plate Locations and Film Locations
Caterpillar engines are identified by serial numbers and by arrangement numbers. These numbers are shown on the engine serial number plate. Caterpillar dealers need these numbers in order to determine the components that were included with the engine. This permits accurate identification of replacement part numbers.
The engine serial number plate is located on the upper left side of the engine block above the fuel injection pump.
Show/hide table
Illustration 1 | g01223267 |
Serial number plate |
Caterpillar Information System:
C3.3 Industrial Engine Product Lifting
C3.3 Industrial Engine Product Storage
C3.3 Industrial Engine Reference Numbers
C3.3 Industrial Engine Refill Capacities and Recommendations
C3.3 Industrial Engine Severe Service Application - Check
C3.3 Industrial Engine Stopping the Engine
C3.3 Industrial Engine Turbocharger - Inspect - If Equipped
C3.3 Industrial Engine Walk-Around Inspection
C3.3 Industrial Engine Water Pump - Inspect
Air/Fuel Ratio Control Control Target Setpoints
CX28 On-Highway Transmission Transmission Charge Pump and Support - Assemble
CX28 On-Highway Transmission Transmission Charge Pump and Support - Disassemble
C3.3 Industrial Engine Overhaul Considerations
Air/Fuel Ratio Control Nitrogen Oxide Sensor Calibration
C15 and C18 Engines Belts - Inspect/Adjust/Replace
2007/07/09 New Software is Now Available {1901, 1902, 7620}
C3.3 Industrial Engine Fuel and the Effect from Cold Weather
G3500B Engines Air/Fuel Ratio Control - Adjust - NO<SUB>X</SUB> Feedback
3512C Industrial Engine Camshaft - Remove
Combining Machined Connecting Rods and Fractured Connecting Rods in Some On-highway Engines{1225} Combining Machined Connecting Rods and Fractured Connecting Rods in Some On-highway Engines{1225}
Air/Fuel Ratio Control Diagnostic Display
C15 and C18 Generator Set Engines Fan Guard - Remove and Install
C3.3 Industrial Engine Fuel System Secondary Filter - Replace
C3.3 Industrial Engine Fuel System Primary Filter (Water Separator) Element - Replace