Water Pump - Inspect
A failed water pump may cause severe engine overheating problems that could result in the following conditions:
- Cracks in the cylinder head
- A piston seizure
- Other potential damage to the engine
Note: The water pump seal is lubricated by the coolant in the cooling system. It is normal for a small amount of leakage to occur as the engine cools down and parts contract.
Visually inspect the water pump for leaks. Renew the water pump seal or the water pump if there is an excessive leakage of coolant. Refer to Disassembly and Assembly, "Water Pump - Remove" for the disassembly procedure and then refer to Disassembly and Assembly, "Water Pump - Install" for the assembly procedure.
Caterpillar Information System:
Air/Fuel Ratio Control Control Target Setpoints
CX28 On-Highway Transmission Transmission Charge Pump and Support - Assemble
CX28 On-Highway Transmission Transmission Charge Pump and Support - Disassemble
3512C Industrial Engine Vibration Damper - Remove and Install
CX28 On-Highway Transmission Transmission Charge Pump and Support - Install
Inspection and Salvage of Rear Wheel Spindles for All Off-Highway Trucks {4201, 4205} Inspection and Salvage of Rear Wheel Spindles for All Off-Highway Trucks {4201, 4205}
C7 Marine Engine Piston Cooling Jet
C7 Marine Engine Piston Cooling Jet
C7 Marine Engine Piston Cooling Jet
C7 Marine Engine Piston Cooling Jet
C9 Petroleum Engines Diagnostic Flash Code Retrieval
Cleaning the Compression Brake{1129} Cleaning the Compression Brake{1129}
C3.3 Industrial Engine Walk-Around Inspection
C3.3 Industrial Engine Turbocharger - Inspect - If Equipped
C3.3 Industrial Engine Stopping the Engine
C3.3 Industrial Engine Severe Service Application - Check
C3.3 Industrial Engine Refill Capacities and Recommendations
C3.3 Industrial Engine Reference Numbers
C3.3 Industrial Engine Product Storage
C3.3 Industrial Engine Product Lifting
C3.3 Industrial Engine Plate Locations and Film Locations
C3.3 Industrial Engine Overhaul Considerations
Air/Fuel Ratio Control Nitrogen Oxide Sensor Calibration
C15 and C18 Engines Belts - Inspect/Adjust/Replace