Transmission Oil Temperature Is High
Use this procedure in order to troubleshoot high transmission oil temperature. Use this procedure if the following event code is active. Refer to Troubleshooting, "Event Code List" for information about event codes and the default trip points for these codes. You must access the monitoring system on Caterpillar Electronic Technician (ET) in order to view the current trip points for these codes.
Show/hide table
Event Code | ||
---|---|---|
Code and Description | Conditions which Generate this Code | System Response |
E030(1) High Transmission Oil Temperature | The transmission oil temperature is above the programmed trip point for the specified delay time. | The code is logged. |
- Transmission oil level
- Transmission oil cooler
- Check the oil level of the transmission.
- If the transmission has an excessive oil level, remove excess oil. Locate the source of the extra oil and make the necessary repairs.
- Check for restrictions in the relief valve and make the necessary repairs.
- Refer to the service information that is from the Original Equipment Manufacturer (OEM) for additional information that is related to the operation and the repair of the transmission.
- Check for restrictions in the relief valve and make the necessary repairs.
- Refer to the service information that is from the Original Equipment Manufacturer (OEM) for additional information that is related to the operation and the repair of the transmission.
Caterpillar Information System:
C18 Marine Engines Transmission Oil Pressure Is High
C3.4 IND Industrial Engine Plate Locations and Film Locations
C3.3 and C4.4 Rental Generator Sets Control Panel
C13 Engine Engine Oil Pan - Remove and Install
C13 Engine Camshaft - Install
C13 Engine Camshaft - Remove
C18 Marine Engines Fuel Level - Test
Torque on the Impeller Bolt on Remanufactured Water Pumps{1361} Torque on the Impeller Bolt on Remanufactured Water Pumps{1361}
C3.3 and C4.4 Rental Generator Sets Starting the Engine
2007/05/21 An Update for Calibrating the Engine Oil Level Gauge {1326}
Inspection Procedures and Specifications for Pistons and Piston Pins {1214, 1214} Inspection Procedures and Specifications for Pistons and Piston Pins {1214, 1214}
C15 On-Highway Engine Diesel Particulate Filter
2007/04/23 100% Leak Testing of Oil Coolers {1378}
2007/04/30 100% Leak Testing of Oil Coolers {1378}
2007/05/01 100% Leak Testing of Oil Coolers {1378}
2007/07/16 Managing the Life Cycles of Excavator Final Drives {4050}
C13 Engine Flame Detection Temperature Sensor - Remove and Install
C13 and C15 On-highway Engines Test ECM Mode
3500C Marine Engines Engine Speed/Timing Sensor
C3.4 IND Industrial Engine Emissions Certification Film
C18 Marine Engines Engine Top Speed Is Not Obtained
C15 On-Highway Engine Clean Gas Induction Temperature Sensor - Remove and Install
C13 Engine Air Pump (ARD Purge) - Remove
2007/04/30 An Improved Starting Motor is Now Available {1453}