| |
| Illustration 1 | g02615483 |
|
Components of the Communication Adapter 3 Gp (317-7484) are listed: (1) Current version of Cat® Electronic Technician (Cat ET) Service Tool software for use with a Windows-based personal computer (2) 317-7485 Control Gp-Electronic (Com Adapter 3) (3) 327-8981 Cable As. (Data Link Cable CA3) (4) 370-4617 Cable As. (CA3 PC USB Cable) | |
Note: Plus+1 Service Tool for Caterpillar software will be required in addition to Cat ET software.
The following service tools should be used to aid in troubleshooting the electrical system.
| Service Tools | |
|---|---|
| Part Number | Part |
| JERD2129 | Most Recent Version of Cat® Electronic Technician (Cat ET) Service Tool |
| Windows-based PC | |
| 8T-3224 | Needle Tip Group |
| 7X-1710 | Multimeter Probe Group |
| 8T-8726 | Cable Assembly (Three Pin) (3-Pin Breakout) |
| 6V-3000 | Connector Repair Kit (Sure Seal) |
| 190-8900 | Connector Repair Kit (Deutsch) |
| 175-3700 | Connector Repair Kit (Deutsch DT) |
| 317-7484 | Communication Adapter 3 Gp |
| One of the Following Digital Multimeters | |
| 237-5130 | Digital Multimeter |
| 257-9140 | Digital Multimeter |
| 146-4080(1) | Digital Multimeter Gp |
| (1) | This multimeter can use an RS232C cable to connect to a Laptop computer or Dataview tool group for troubleshooting. |
For instructions on servicing Sure Seal connectors, see Special Instruction, SMHS7531. For service instructions about the Deutsch "DT" Type connectors, see Special Instruction, SEHS9615.
Cat® Electronic Technician (Cat ET) Service Tool is not required to determine and clear the diagnostic codes. However, the process of determining the diagnostic codes is easier and faster by using Cat ET. Cat ET can also display information on the history of a diagnostic code and the parameter status of diagnostic codes. These features allow Cat ET to be a useful tool for troubleshooting.
Use the digital multimeter for making continuity checks or for measuring voltage. For instructions about the use of the Digital Multimeter, see the owners manual that is provided with the multimeter. The 7X-1710 Multimeter Probe is used to measure the voltage at the connectors without disconnecting the connectors. The probe cables are pushed into the back of the connector along the wire. The 8T-8726 Adapter Cable has a three-pin breakout. The adapter cable is used for measurements in the sensor circuits.
Note: Except for harness tests, using continuity testers such as the 8T-0500 Continuity Tester or voltage testers such as the 5P-7277 Voltage Tester is not recommended for today's Cat electrical circuits.