993K Wheel Loader Power Train Caterpillar

Transmission Oil Pump - Remove

Usage:

993K Z4D

Removal Procedure

Show/hide table

Table 1
Required Tools
Tool	Part Number	Part Description	Qty
A	138-7575	Link Bracket	1

Start By:

Lower the guard for the transmission.
Remove the rear drive shaft if additional clearance is necessary.

Show/hide table

NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates.

Note: Cap all hydraulic lines and fittings that are disconnected in order to prevent oil loss. Capping hydraulic lines will also keep contaminants out of the hydraulic system.

Drain the oil in the pump drive into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Transmission Oil - (Change)".
Show/hide table

Illustration 1 g03039737
The transmission oil pump is located on the front left side of the pump drive. Loosen clamps (1) and slide hose (2) onto tube assembly (3).
Show/hide table

Illustration 2 g03040096
Disconnect hose assembly (4) and reposition resonator assembly (5). Disconnect line (6) and remove tube assembly (7).
Show/hide table

Illustration 3 g03040476
Attach Tooling (A) and a suitable lifting device to transmission oil pump (8). The weight of transmission oil pump (8) is approximately 33 kg (72 lb). Remove bolts (9) and transmission oil pump (8) through the bottom of the machine.
Show/hide table

Illustration 4 g03040538
Remove nut (10), gear (11), and gasket (12).